Replacing The Fuse; Lubricating The Wheel Gears; Replacing The Blade - Toro 20793 Super Recycler Operator's Manual

53cm lawn mower
Table of Contents

Advertisement

Figure 46
5. Install the dipstick securely.
6. Dispose of the used oil properly at a local recycling
center.
Charging the Battery
Service Interval: Every 25 hours
Before storage
Model 20795 only
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling battery.
Charge the battery for 24 hours initially, then monthly
(every 25 starts) or as needed. Always use the charger in
a sheltered area and charge the battery at a temperature
between 32°F (0°C) and 105°F (41°C) whenever
possible.
1. Connect the charger to the mower wire harness
located below the ignition key (Figure 47).
Figure 47
2. Plug the charger into a wall outlet.
Note: When the battery no longer holds a charge,
recycle or dispose of the lead-acid battery according
to local codes.
Note: Your battery charger may have a two-color LED
display that indicates the following states of charging:
• A red light indicates that the charger is charging the
battery.
• A green light indicates that the charger is fully
charged or the charger is disconnected from the
battery.
• A flashing light that alternates between red and green
indicates that the battery is nearly fully charged. This
state lasts only a few minutes until the battery is fully
charged.

Replacing the Fuse

Model 20795 only
If the battery does not charge or the engine does not
turn with the electric starter, the fuse may be blown.
Replace it with a 40-amp plug-in type fuse. Refer to
Installing the Fuse.

Lubricating the Wheel Gears

Service Interval: Every 25 hours
1. Wipe the grease fittings just inside the rear wheels
with a clean rag (Figure 48).
2. Install a grease gun onto each fitting and gently apply
2 or 3 pumps of #2 multi-purpose lithium-base
grease.

Replacing the Blade

Service Interval: Yearly
Important: You will need a torque wrench to install
the blade properly . If you do not have a torque
wrench or are uncomfortable performing this
procedure, contact an Authorized Service Dealer.
19
Figure 48

Advertisement

Table of Contents
loading

This manual is also suitable for:

20795 super recycler

Table of Contents