Table of Contents
Advertisement
• Stop the engine and disconnect the spark-plug wire.
– before clearing blockages or unclogging chute.
– before checking, cleaning or working on the lawn
mower.
– after striking a foreign object, inspect the lawn
mower for damage and make repairs before
restarting and operating the lawn mower.
– if lawn mower starts to vibrate abnormally (check
immediately).
• Watch out for traffic when crossing or near roadways.
Maintenance and Storage
• Keep all nuts, bolts and screws tight to be sure the
equipment is in safe working condition.
• Do not use pressure cleaning equipment on machine.
• Never store the equipment with gasoline in the tank
and inside a building where fumes can reach an open
flame or spark.
• Allow the engine to cool before storing in any
enclosure.
• To reduce the fire hazard, keep the engine, silencer,
battery compartment and gasoline storage are free of
grass, leaves, or excessive grease.
• Check grass catcher components and the discharge
guard frequently and replace with manufacturer's
recommended parts, when necessary.
• Replace worn or damaged parts for safety.
• Replace faulty silencers.
• If the fuel tank has to be drained, do this out-doors.
• Do not change the engine governor settings or
overspeed the engine. Operating an engine at
excessive speed can increase the hazard of personal
injury.
• On multibladed lawn mowers, take care as rotating
one blade may cause others to rotate.
• Be careful during adjustment of the lawn mower to
prevent entrapment of the fingers between moving
blades and fixed parts of the lawn mower.
• To ensure the best performance and safety,
purchase only genuine Toro replacement parts
and accessories. Do not use will fit parts and
accessories; they may cause a safety hazard.
Sound Pressure
This unit has a maximum sound pressure level at the
operator's ear of 89 dBA, based on measurements of
identical machines per EN 836 and ISO 11201.
Sound Power
This unit has a guaranteed sound power level of 98 dBA,
based on measurements of identical machines per ISO
11094.
Vibration, Hand/arm
This unit does not exceed a hand/arm vibration level of
7.0 m/s2, based on measurements of identical machines
per EN 836 and EN 1033.
3
Advertisement
Table of Contents
