Toro Super Recycler 20794 Operator's Manual
Toro Super Recycler 20794 Operator's Manual

Toro Super Recycler 20794 Operator's Manual

53cm lawn mower
Hide thumbs Also See for Super Recycler 20794:

Advertisement

Quick Links

53cm Super Recycler
Model No. 20794—Serial No. 280000001 and Up
Model No. 20796—Serial No. 280000001 and Up
Introduction
Read this information carefully to learn how to operate
and maintain your product properly and to avoid injury
and product damage. You are responsible for operating
the product properly and safely.
You may contact Toro directly at www.Toro.com for
product and accessory information, help finding a
dealer, or to register your product.
Whenever you need service, genuine Toro parts, or
additional information, contact an Authorized Service
Dealer or Toro Customer Service and have the model
and serial numbers of your product ready. Figure 1
identifies the location of the model and serial numbers
on the product.
Figure 1
1. Model and serial number plate
Write the product model and serial numbers in the space
below:
Model No.
Serial No.
This manual identifies potential hazards and has
safety messages identified by the safety alert symbol
(Figure 2), which signals a hazard that may cause serious
injury or death if you do not follow the recommended
precautions.
© 2008—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
®

Lawn Mower

1. Safety alert symbol
This manual uses 2 words to highlight information.
Important calls attention to special mechanical
information and Note emphasizes general information
worthy of special attention.
For models with stated engine horsepower, the gross
horsepower of the engine was laboratory rated by the
engine manufacturer in accordance with SAE J1940.
As configured to meet safety, emission, and operating
requirements, the actual engine horsepower on this class
of lawn mower will be significantly lower.
Safety
Improperly using or maintaining this mower can
result in injury. To reduce the potential for injury,
comply with these safety instructions.
Toro designed and tested this mower for reasonably safe
service; however, failure to comply with the following
instructions may result in personal injury.
To ensure maximum safety, best performance, and
to gain knowledge of the product, it is essential
that you and any other operator of the mower read
and understand the contents of this manual before
the engine is ever started. Pay particular attention
to the safety alert symbol (Figure 2) which means
Caution, Warning, or Danger—"personal safety
instruction." Read and understand the instruction
because it has to do with safety. Failure to comply
with the instruction may result in personal injury.

General Lawn Mower Safety

The following instructions have been adapted from EN
836.
This cutting machine is capable of amputating hands
and feet and throwing objects. Failure to observe the
Register at www.Toro.com.
Form No. 3359-358 Rev A
Operator's Manual
Figure 2
Original Instructions (EN)
Printed in the USA
All Rights Reserved

Advertisement

Table of Contents
loading

Summary of Contents for Toro Super Recycler 20794

  • Page 1: Lawn Mower

    Authorized Service horsepower of the engine was laboratory rated by the Dealer or Toro Customer Service and have the model engine manufacturer in accordance with SAE J1940. and serial numbers of your product ready. Figure 1...
  • Page 2 following safety instructions could result in serious • Do not tilt mower when starting the engine or injury or death. switching on the motor, unless the mower has to be tilted for starting. In this case, do not tilt it more than Training absolutely necessary and lift only the part, which is away from the operator.
  • Page 3: Sound Power

    • Be careful during adjustment of the lawn mower to prevent entrapment of the fingers between moving blades and fixed parts of the lawn mower. • To ensure the best performance and safety, purchase only genuine Toro replacement parts will fit and accessories. Do not use parts and accessories;...
  • Page 4: Safety And Instructional Decals

    Safety and Instructional Decals Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals. Manufacturer’s Mark 1. Indicates the blade is identified as a part from the original machine manufacturer. 104-7908 1. Warning—do not operate the mower without the rear discharge plug or bag in place;...
  • Page 5 112-8867 1. Lock 2. Unlock 114-7982 1. Warning—read the 4. Cutting/dismemberment Operator’s Manual. hazard of hand or foot, mower blade—stay away from moving parts. 2. Thrown object 5. Cutting/dismemberment hazard—keep bystanders hazard of hand or foot, a safe distance from the mower blade—do not machine.
  • Page 6: Assembling And Unfolding The Handle

    Setup Important: Remove and discard the protective plastic sheet that covers the engine. 1. Assembling and Unfolding the Handle Procedure Assembling and unfolding the handle improperly can damage the cables, causing an unsafe operating condition. • Do not damage the cables when assembling and unfolding the handle.
  • Page 7: Installing The Starter Rope

    2. Installing the Starter Rope 4. Installing the Fuse Procedure Procedure Pull the starter rope through the rope guide on the Model 20796 only handle (Figure 5). Your mower comes with a 40-amp fuse that protects the electric starter. Important: You cannot start the mower with the electric starter or charge the battery unless you install the fuse.
  • Page 8: Product Overview

    Product Overview Operation Filling the Fuel Tank Gasoline is extremely flammable and explosive. A fire or explosion from gasoline can burn you and others. • To prevent a static charge from igniting the gasoline, place the container and/or mower directly on the ground before filling, not in a vehicle or on an object.
  • Page 9: Checking The Engine Oil Level

    Checking the Engine Oil Level Service Interval: Before each use or daily 1. Remove the dipstick, wipe it clean, and fully install the dipstick (Figure 12). Figure 13 Figure 12 2. Remove the dipstick and check the oil level Adjusting the Handle Height (Figure 12).
  • Page 10: Starting The Engine

    Starting the Engine Using the Self-propel Drive 1. Pull the blade control bar to the handle (Figure 15). To operate the self-propel drive, simply walk with your hands on the upper handle and your elbows at your sides, and the mower will automatically keep pace with you (Figure 18).
  • Page 11: Bagging The Clippings

    Check the grass bag frequently. If it is If you do not see them, firmly push the plug in until damaged, install a new Toro replacement bag. it snaps into place (Figure 21). If the side discharge chute is on the mower, remove it and lock the side discharge door (refer to Removing the Side Discharge Chute) before bagging the clippings.
  • Page 12: Removing The Grass Bag

    Note: The lower rope guide releases the starter rope when you pull the recoil start handle. 2. Raise and hold up the discharge deflector. 3. Lift the grass bag up by the handle off the notches. 4. Install the rear discharge plug (Figure 26). Figure 23 1.
  • Page 13: Side-Discharging The Clippings

    Side-discharging the Clippings Use the side discharge for cutting very tall grass. If the bag is on the mower, remove it and insert the rear discharge plug (refer to Removing the Grass Bag) before side-discharging the clippings. Figure 30 Important: Ensure that the rear discharge plug is securely in place.
  • Page 14: Operating Tips

    • Slow down your mowing speed if the mower does cutting season begins. not cut the leaves finely enough. • Replace the blade when necessary with a Toro replacement blade. Cutting Grass • Cut only about a third of the grass blade at a time.
  • Page 15: Replacing The Air Filter

    Maintenance Note: Determine the left and right sides of the machine from the normal operating position. Recommended Maintenance Schedule(s) Maintenance Service Maintenance Procedure Interval • Change the engine oil. After the first 5 hours • Check the engine oil level. •...
  • Page 16: Changing The Engine Oil

    Replacing the Air Filter Service Interval: Yearly 1. Perform the pre-maintenance procedures; refer to Preparing for Maintenance. 2. Use a screw driver to open the air filter cover (Figure 35). Figure 37 3. Tip the mower onto its side, with the air filter up, to drain the used oil out through the oil fill tube (Figure 38).
  • Page 17: Lubricating The Wheel Gears

    Charging the Battery Lubricating the Wheel Gears Service Interval: Every 25 hours Service Interval: Every 25 hours Before storage 1. Wipe the grease fittings just inside the rear wheels with a clean rag (Figure 41). Model 20796 only Charge the battery for 24 hours initially, then monthly (every 25 starts) or as needed.
  • Page 18: Cleaning The Mower

    1. Lower the mower to its lowest cutting height setting. Refer to Adjusting the Cutting Height. 2. Move the mower onto a flat paved surface. 3. Attach a garden hose that is connected to a water supply to the washout port on the mower housing (Figure 43).
  • Page 19: Folding The Handle

    Storage 1. Rotate the handle forward (Figure 44). Important: Route the cables to the outside of Store the mower in a cool, clean, dry place. the handle knobs as you fold the upper handle. Preparing the Mower for Storage Gasoline vapors can explode. •...
  • Page 20 Notes:...
  • Page 21 Notes:...
  • Page 22 Notes:...
  • Page 23 Spypros Stavrinides Limited Cyprus 357 22 434131 Surge Systems India Limited India 91 1 292299901 T-Markt Logistics Ltd Hungary 36 26 525 500 Toro Australia Australia 61 3 9580 7355 Toro Europe BVBA Belgium 32 14 562 960 374-0102 Rev B...
  • Page 24 Contact your seller to arrange service of the product. If for any reason materials or workmanship. The following time periods apply from the date it is impossible for you to contact your seller, you may contact any Toro of original purchase: Authorized Distributor to arrange service.

This manual is also suitable for:

Super recycler 20796

Table of Contents