Connecting To A Dolby Digital Decoder Or An Amplifier With Built-In Dts (Dvd Deck Only) - JVC HR-XVC37U Instructions Manual

Connecting To A Dolby Digital Decoder
or An Amplifier With Built-in DTS
(DVD deck only)
These instructions enable you to connect your unit to a Dolby Digital Decoder or an amplifier with built-in DTS.
To DIGITAL AUDIO
input
Make connections.
Connect the unit and a Dolby Digital Decoder or an
amplifier with built-in DTS using either an optional
optical cable or an optional coaxial cable.
NOTES:
For Dolby digital sound, set "DIGITAL AUDIO OUTPUT" to
"DOLBY DIGITAL/PCM". (
For DTS sound, set "DIGITAL AUDIO OUTPUT" to "STREAM/
PCM". ( pg. 79)
Dolby Digital Decoder or
amplifier with built-in DTS
Remove the protection cap from
Optical cable (not supplied)
Coaxial cable (not supplied)
pg. 79)
DIGITAL AUDIO OUT
(OPTICAL)
1
Back of unit
Note for connection:
the optical cable.
CAUTIONS:
This unit has a dynamic range of more than 80 dB with regards
to its Hi-Fi audio capability. It is recommended that you check
the maximum level if you are going to listen to the Hi-Fi audio
signals through a stereo amplifier. A sudden surge in the input
level to the speakers may damage them.
Some speakers and televisions are specially shielded to
prevent television interference. If both are of the non-shielded
type, do not place the speakers adjacent to the TV set as this
can adversely affect the video playback picture.
EN
DIGITAL AUDIO OUT
(COAXIAL)
73