JVC HR-DVS2U Instructions Manual page 20

20
EN
NUMBER
1
T W
1 2 3
2
4 5 6
7 8 9
0
4
DV S-VHS
INITIAL SETTINGS (cont.)
ACCESS DBS RECEIVER
BRAND SET SCREEN
7
Press OK.
SET DBS RECEIVER BRAND
8
Press the appropriate
NUMBER keys to enter the
DBS Receiver Code from
the following list, then
press OK.
BRAND
JVC (DISH Network)
ECHOSTAR (DISH Network)
PRIMESTAR
SONY (DSS)
RCA (DSS)
After OK is pressed, the program currently received
through the DBS receiver will appear for about 10
seconds.
If the DBS receiver's channel changes to the channel
listed below for your brand of DBS receiver, setting is
complete. Press OK and "DBS RECEIVER CONTROL
IS ON" appears on the screen for about 5 seconds,
then it returns to the normal screen.
JVC [ 100
ECHOSTAR [ 100
PRIMESTAR [ 55
SONY [ 205
RCA [ 205
If the DBS receiver's channel does not change as
shown above, press %fi to move the highlight bar
(arrow) to "NO", then press OK. Re-enter the correct
code.
NOTES:
It is possible that the Controller will not work with all types of
DBS receiver.
If your DBS receiver doesn't respond to the code, you can't
use the Controller to change satellite channels. In this case,
make sure to leave the DBS receiver turned on and tuned to
the proper channel before the scheduled start of timer
recording.
The VCR can only change the satellite channel through the
Controller during timer recording.
If your DBS receiver is one that can't be operated with a
remote control (because it has no remote sensor), you can't
use the Controller to change its channels. Make sure to leave
the DBS receiver turned on and tuned to the proper channel
before the scheduled start of timer recording.
If you are unable to set the Controller, please contact JVC toll
free at 1-800-537-5722.
DBS RECEIVER BRAND SET
4 0
PRESS NUMBER KEY (0–9)
THEN (OK) TO TEST
PRESS (MENU) TO END
CODE
51
51
50
41
40