Video Navigation; Navigation Playback - JVC HM-DH30000U Instructions Manual

42
EN
Navigation
Playback
Turn on the VCR and the TV, and select the AV
mode on the TV.
VCR TV CABLE/DBS
1
4
7
2
A
2,3
–
A
1,4
–
NOTES:
If you press NAVIGATION while Video Navigation is deactivated, "NAVIGATION: OFF" appears (with "SUPERIMPOSE" set to
"ON": pg. 56).
Video Navigation playback is possible only with the tape recorded on this VCR.
To record the date and time as the program title in this VCR's memory, make sure the VCR's clock is set correctly before recording.
To record the program information in this VCR's memory, you must record each program for over the minimum recording time; 5
min for the D-VHS (HS) mode, 10 min for the D-VHS (STD) mode, 30 min for the D-VHS (LS3) mode, 5 min for the S-VHS/VHS
(SP) mode and 15 min for S-VHS/VHS (EP) mode.
Video Navigation may not work properly for some tapes.
If the VCR finds two tape numbers in one tape while playing back or searching for the beginning of a program, the tape will be
assigned just one number (smaller number) when you remove the tape.
The program information is stored in this VCR's memory. Should the memory in this VCR be damaged and the program information
be lost, it is impossible to restore that information.
After recording a tape on this VCR, write the tape number on a label and affix the label to the tape in order to allow you to find the
tape by its number.
2 3
5 6
8 9
0
A
3
–
2
4
A
This function is useful when you want to quickly find out
what programs you have recorded on a tape using this
VCR. This function allows you to select a program to
watch, and then automatically searches for the
beginning of the program.
1
Load a cassette
Insert a tape recorded on this VCR.
The VCR turns on automatically.
The counter is automatically reset to "0:00:00".
The tape will run for a few seconds while the
VCR searches for the tape number recorded. If
tape number is found, it will be shown on the
TV screen if "SUPERIMPOSE" is set to "ON".
( pg. 56)
If the cassette's record safety tab has been
removed, playback begins automatically.
2
Access Title screen
Press NAVIGATION.
After pressing
NAVIGATION, it may
take a few seconds to
access the Title screen
while the VCR
searches for the Video
Navigation information.
3
Select program
Press %fi to move the highlight bar (arrow) to the
program you want to watch.
4
Start playback
Press OK.
2
–
Playback starts automatically after the selected
program is located.

VIDEO NAVIGATION

] 0107 ALL SPORTS TAPE
BLANK 2:00 (LS3) [ 1/ 3]
3 12/21 SYDNEY OLYMPIC
10/11 FOOTBALL
BLANK 2:00 (LS3)
∞
1/ 1 EURO 96 ENGLAND
12/21/01 DBS 256 SHOW
6:30AM= 5:53PM 11:23 (LS3)
PRESS (5∞), THEN (OK) TO
SEARCH , EDIT LIBRARY (0)