Setting Dbs Receiver Output Channel & Brand - JVC HM-DH30000U Instructions Manual

Turn on the VCR and the TV, and select the AV
mode on the TV.
VCR TV CABLE/DBS
1
4
7
3 4
2
2 3
5 6
8 9
0
5
3 4
Setting DBS receiver output
channel & brand
After installation, set the DBS receiver's output channel
and its brand correctly; otherwise, the Controller cannot
work correctly.
1
Turn on DBS receiver
Select a channel other than channel 55, 100 or
205 on your DBS receiver.
2
Access Main Menu screen on VCR
Press MENU.
3
Access Tuner Set Up screen
Press %fi to move the highlight bar (arrow) to
"TUNER SET UP", then press OK.
4
Access DBS Receiver Set screen
Press %fi to move the
highlight bar (arrow) to
"DBS RECEIVER SET
UP", then press OK.
5
Select DBS receiver output channel
Your selection depends on how your DBS
receiver is connected to your VCR.
If your DBS receiver
is connected to your
VCR's ANTENNA IN
terminal on the rear
panel
Press @ # until the
channel number
representing the DBS
receiver's output (CH3 or CH4) appears on the
screen.
If your DBS receiver is connected to your VCR's
AUDIO/VIDEO IN connectors on the front panel
Press @ # until "ON F-1 (FRONT)" appears on
the screen.
If your DBS receiver is connected to your VCR's
AUDIO/VIDEO IN (L-1) or AUDIO/VIDEO IN
(L-2) connectors on the rear panel
Press @ # until "ON L-1 (REAR)" or "ON L-2
(REAR)" appears on the screen.
If you do not use a DBS receiver
Press @ # until "OFF" appears on the screen.
CONTINUED ON NEXT PAGE \
19
EN
TUNER SET UP
BAND CATV
AUTO CHANNEL SET UP
MANUAL CHANNEL SET
GUIDE CHANNEL SET
CABLE BOX SET UP
3 DBS RECEIVER SET UP
PRESS (5∞), THEN (OK)
PRESS (MENU) TO END
DBS RECEIVER SET UP
OFF
PRESS (2 3), THEN (OK)
PRESS (MENU) TO END