Stove; Assembling Fera 60 Stove - KAL-FIRE Fera series Installation And Operating Instructions Manual

attached
plate
fireproof
= material
compulsory
A
Drawing 10.1 Drawing 10.2
* It is not necessary that the mantle is suspended to the attaching plate
It is only secured so that the mantle cannot topple over.
27
A
see *
A
Drawing 10.3
2.5 Fera 60 stove
The mantle and main frame are fully checked at our factory for
possible damages prior to their packing. Nevertheless, please verify
the appliance for possible transport damage before installing it.
Contents of the Fera 60 stove consist of:
• Main frame of the stove and mantle.
• Fera 60 with ultrasonic remote control.
The Fera 60 stove is delivered packed in a cardboard
box on a Euro pallet. Carefully remove the cardboard
box by lifting it up. Next you will see the mantle
wrapped in protective tubular foam, which has to be
removed very carefully without damaging the paintwork
with the knife.
2.5.1

Assembling Fera 60 stove

1. Remove the mantle from the stove by lifting it up.
2. Carefully take out the Fera appliance from the main frame and
put it aside in a safe place.
3. Take the main frame from the stove off the pallet and drill a
hole in the backside or bottom plate, through which the gas
line can be introduced and if necessary make 2 holes for
securing the stove against the wall.
4. Put the floor plate at the spot where the stove will be
installed. Put the main frame onto the floor plate and level
out with the adjusting feet.
5. Hang the suspension bracket for the upper basket on the wall
and secure it at the top with 2 screws.
suspension bracket can be clamped around the steel of the

stove.

6. On top and at the sides of the Fera there are all together 4
(not yet opened) convection holes. Open all 4 convection
holes.
7. Put the Fera 60 into the main frame (2 man) by:
1. obliquely introducing the stove (starting at the
top).
2. taking hold of the stove at the top (through the
main frame) at the flue gas connection.
the stove.
3. Make sure it fits between the two notches at the
backside bottom of the main frame.
28
The bottom of the
Pull up