Yamaha YP250R 2005 Service Manual page 180

1
2
b
1
b
a
HANDLEBAR
2. Install:
• handlebar 1
• upper handlebar holders 2
CAUTION:
First, tighten the bolt on the front side of
the handlebar holders, and then on the rear
side.
NOTE:
• The upper handlebar holders should be
installed with the arrow marks a facing for-
ward È.
• Align the match mark b on the handlebar
with the upper surface of the lower handlebar
holder.
3. Install:
• handlebar grip
M MMM M MMM M M MMM
a. Apply a thin coat of rubber adhesive onto
the left end of the handlebar.
b. Slide the handlebar grip over the left end of
the handlebar.
c. Wipe off any excess rubber adhesive with a
clean rag.
WARNING
Do not touch the handlebar grip until the
rubber adhesive has fully dried.
L LLL L LLL L L LLL
4. Install:
• rear brake master cylinder 1
• rear brake master cylinder holder
NOTE:
• Align the projection a on the brake master
cylinder with the hole b in the handlebar.
• First tighten the front bolt, then the rear bolt.
4 - 62
CHAS
23 Nm (2.3 m · kg, 17 ft · lb)
M M MMM M M MMM M
L L LLL L L LLL L
7 Nm (0.7 m · kg, 5.1 ft · lb)
M MMM M MMM
L LLL L LLL