General Procedures and Information
GP 9 Error Messages
Display
Door Open
Hsync Error
[Invalid Cartridge]
Low Heat Error
[LSU Error]
[No Paper]
Add Paper
Open Heat Error
[Over Heat]
[Paper Jam 0]
Open/Close Door
[Paper Jam 1]
Open/Close Door
[Paper Jam 2] Check
inside
Power failure
Scanner Error
6-42
Meaning
The front cover is not securely
latched
A problem has occured in the
LSU (Laser Scanning Unit)
There is an invalid toner installed Install authorised toner cartridge, PL 1
There is a problem in the fuser
unit
A problem has occured in the
LSU (Laser Scanning Unit
The paper in the input tray has
run out.
There is a problem in the fuser
unit.
There is a problem with the fuser
unit.
Paper has jammed in the feeding
area of the paper input tray.
Paper has jammed in the fuser
area or in the bypass feeder
Paper has jammed in the paper
exit area.
Power has turned off then on and
the machine's memory has not
been backed up.
There is a problem in the scanner
unit.
Table 1:
Close the front cover, PL 1 until it locks into place.
Unplug the power cord, PL 1 and plug it back in.
Unplug the power cord, PL 1 and plug it back in. If the
problem persists, please call for service.
Unplug the power cord, PL 1 and plug it back in. If the
problem persists, please call for service.
Load paper in the cassette assembly, PL 9.
Unplug the power cord, PL 1 and plug it back in. If the
problem persists, please call for service.
Unplug the power cord, PL 1 and plug it back in.
Clear the jam, GP 6.
Clear the jam, GP 6.
Clear the jam, GP 6.
The job which you were trying to do before the power
failure must be completely re-done.
Unplug the power cord, PL 1 and plug it back in. If the
problem persists, please call for service.
06/06
Suggested solutions
WorkCentre 3119