Table of Contents
Advertisement
Setting The Crossover Frequency
By setting the crossover frequency, frequencies lower than the
frequency being set is output from the subwoofer.
1
Press SETTING.
The item of the setting performed most recently is displayed on
the front display panel.
2
Press F or G to display ACROSS :B on the front display panel.
3
Press D or E to select the frequency.
Each time you press D or E, the display changes as follows:
80HzN100HzN120HzN150HzN200HzN (back to the
beginning)
Select one of the crossover frequency according to size of the
connected speaker.
Select this when using cone speaker that is about
80Hz
12 cm.
Select this when using cone speaker that is about
100Hz
10 cm.
Select this when using cone speaker that is about
120Hz
8 cm.
Select this when using cone speaker that is about
150Hz
6 cm. (Default)
Select this when using cone speaker that is about
200Hz
5 cm.
Setting The Midnight Mode
You can enjoy powerful sounds at night by setting the midnight
mode.
1
Press SETTING.
The item of the setting performed most recently is displayed on
the front display panel.
2
Press F or G to display ANIGHT :B on the front display panel.
3
Press D or E to select the mode.
Each time you press D or E, the display changes as follows:
NIGHT : 1NNIGHT : 2NNIGHT : OFFN (back to the beginning)
Select one of the following modes.
Select this when you want to reduce the
NIGHT : 1
dynamic range slightly.
Select this when you want to maximise the
NIGHT : 2
compression effect. (Ideal for midnight)
Select this when playing back using full
NIGHT : OFF
dynamic range. (Midnight mode not
activated) (Default)
INITIAL SETTINGS
24
Hide quick links:
Advertisement
Table of Contents
