Operating Other Manufacturers' Video Equipment - JVC SP-PWA9 Instructions Manual

Operating Other Manufacturers' Video Equipment

This remote control supplied with the receiver can transmit control
signals for other manufacturers' VCRs, TVs, CATV converters
and DBS tuners. By changing the transmittable signals from preset
ones to the other manufacturers', you can operate the other manu-
facturer's components using this remote control.
When operating the other manufacturers' components, refer also
to the manuals supplied with them. To operate these components
with the remote control, first you need to set the manufacturer's
code each for VCR, TV, CATV converters, and DBS tuner.
STANDBY/ON
TV/CATV/DBS AUDIO
VCR
AUX FM/AM DVD
TITLE SUBTITLE DECODE AUDIO
ZOOM DIGEST TIME DISPLAY
RETURN ANGLE CHOICE SOUND
CONTROL SUBWOOFER EFFECT
VCR
CENTER TEST
TV
REAR-L
SLEEP
REAR-R
SETTING
TV RETURN FM MODE 100+
AUDIO/
TV/VCR
PLAY
MODE
CATV/DBS
ENTER
THEATER DSP
POSITION MODE
TV VOL CHANNEL VOLUME
TV/VIDEO MUTING
B.SEARCH F.SEARCH
/REW PLAY FF/
DOWN UP
TUNING
STOP
REC PAUSE
MEMORY STROBE
DVD MENU
RM-STHA9U
DVD CINEMA SYSTEM
AUDIO/
TV/VCR
CATV/DBS
Check to see if its
remote control
mode selector is
set to the correct
position.
To operate the
audio system,
TVs, and VCRs,
set it to "AUDIO/
TV/VCR."
To change the transmittable signals for oper-
ating another manufacturer's TV
1
Slide the remote control mode to "AUDIO/TV/
VCR."
2
Press and hold TV/CATV/DBS
Keep press until step 4 is finished.
3
Press TV.
4
Enter manufacturer's code (2 digits) using
buttons 1 - 9, and 0.
See the list below to find the code.
Examples: For a JVC product, press 0, then 1.
For a Hitachi product, press 1, then 0.
5
Release TV/CATV/DBS
The following buttons can be used for operating the TV (with
the remote control mode selector set to "AUDIO/TV/VCR"):
TV/CATV/DBS : Turns on and off the TV.
TV VOL +/–:
Adjusts the volume.
TV/VIDEO:
Sets the input mode (either TV or
VIDEO).
After pressing TV (with the remote control mode selector set
to "AUDIO/TV/VCR"), you can perform the following oper-
ations on a TV:
CHANNEL +/– : Changes the channels.
1 - 10, 0, 100+ (+10):
Selects the channels.
100+ (+10) button will function as
the ENTER button if your TV re-
quires pressing ENTER after se-
lecting a channel number.
Note:
• Refer to the manual supplied with your TV.
6
Try to operate your TV by pressing TV/CATV/
DBS .
When your TV turns on or off, you have entered the correct
code.
If there are more than one code listed for your brand
of TV, try each one until the correct one is entered.
Manufacturer Code
JVC 01
HITACHI 10
MAGNAVOX 02
MITSUBISHI 03
PANASONIC 04, 11
RCA 05
Manufactures' codes are subject to change without notice. If
they are changed, this remote control cannot operate the
equipment.
.
.
Manufacturer Code
SAMSUNG 12
SANYO 13
SHARP 06
SONY 07
TOSHIBA 08
ZENITH 09
55 55 55 55