Subaru 2001 LEGACY Service Manual page 72

Periodic Maintenance Services
B: REPLACEMENT
1. 2.5 L MODEL
SA07684A2004
1) Remove V-belt cover.
NOTE:
Wipe off any oil or water on the belt and pulley.
2) Loosen the lock bolt (A).
3) Loosen the slider bolt (B).
4) Remove the front side belt (C).
5) Loosen the lock nut (A).
6) Loosen the slider bolt (B).
7) Remove the rear side belt.
8) Install a new belt, and tighten the slider bolt so
as to obtain the specified belt tension.
9) Tighten the slider bolt (B).
10) Tighten the lock bolt (A).
DRIVE BELT(S)
SA07684A20
GI0020
GI0021A
GI0022A
PM-12
Tightening torque:
Lock bolt, through bolt:
25 N·m (2.5 kgf-m, 18 ft-lb)
Slider bolt:
8 N·m (0.8 kgf-m, 5.8 ft-lb)
11) Install a new belt, and tighten the slider bolt so
as to obtain the specified belt tension.
12) Tighten the slider bolt (B).
13) Tighten the lock nut (A).
Tightening torque:
22.6 N·m (2.3 kgf-m, 16.6 ft-lb)
2. 3.0 L MODEL
SA07684A2005
1) Fit the tool to the belt tensioner mounting bolt.
2) Turn the tool clockwise, and loosen the V-belt to
remove.
GI0021A
GI0022A
B2M4012