Subaru 2001 LEGACY Service Manual page 51

B: PDI PROCEDURE
Follow the procedures shown in the table below.
Static Checks Just After Vehicle Receipt
Step
1. Appearance check
2. Tire check
3. Fuse installation
4. Connection of air conditioner harness
5. Check the doors for lock/unlock and open/
close operations.
6. Power window operation check
7. Operation check of trunk lock release lever
8. Operation check of rear gate lock release lever (1) Operate the rear gate lock release lever to check that the rear gate is
9. Operation check of fuel lid opener lock release
lever
10. Accessory check
11. Operation check of hood lock release system
12. Battery
13. Brake fluid
14. Engine oil
15. Transmission fluid
16. AT front differential oil
17. Coolant
18. Clutch fluid
19. Window washer fluid
20. Hood latch check
21. Keyless entry system
22. Seat
23. Seat belt
24. Wheel alignment
PRE-DELIVERY INSPECTION
SA09719G50
(1) If the vehicle is covered with protective coating, visually check the
vehicle body for damage and dents. If the protective coating has been
removed, visually check the body paints for small areas of damage or
stains.
(2) Visually check the glass and light lenses for any damage and cracks
or excessive gaps to the body sheet metal.
(3) Visually check the plated parts for any damage.
(1) Check the tires for damage, abnormal conditions, and dents on the
wheels.
(2) Check the tire air pressure.
(1) If the vehicle is about to be delivered to the customer, attach a room
lamp fuse.
(1) If the vehicle is about to be delivered to the customer, connect the air
conditioner harness.
(1) Using the key, check if the door can be locked and unlocked normally.
(2) Open and close the all doors to see that there are no abnormal condi-
tions.
(1) Check the power window for correct operations.
(1) Operate the trunk lock release lever to check that the trunk opens nor-
mally.
unlocked normally.
(1) Operate the fuel lid opener to check that the fuel lid is unlocked nor-
mally.
Check the following accessories are provided:
¼ Owner's manual
¼ Warranty booklet
¼ Service booklet
¼ Spare key
¼ Jack
¼ Tool set
¼ Spare tire
(1) Operate the hood lock release lever to check that the hood opens nor-
mally.
(1) Check the battery for any abnormal conditions such as rust and trace
of battery fluid leaks.
(1) Check the fluid amount.
(1) Check the oil amount.
(1) Check the fluid amount.
(2) For AT, check the front differential oil.
(1) Check the AT front differential oil amount.
(1) Check the coolant amount.
(1) Check the clutch fluid amount.
(1) Check the window washer fluid amount.
(1) Check that the hood is closed and latched securely.
(1) Check that the keyless entry system operates normally.
(1) Check the seat surfaces for smears or dirt.
(2) Check the seat installation conditions and functionality.
(1) Check the seat belt installation conditions and functionality.
(1) Check that the wheel alignments are properly adjusted.
PI-3
Pre-delivery Inspection
Check point