Starting Condition; Exhaust System; Indicator Light; Radio - Subaru 2001 LEGACY Service Manual

25. READ MEMORY AND TEST MODE
CONNECTORS
SA09719G5050
Turn the ignition switch to ON and check that the
check-engine light starts blinking. If the light blinks,
return the ignition key to LOCK and disconnect the
test mode connector. Then, turn the ignition key to
ON again. If the check-engine light blinks at that
time in spite of the disconnected test mode
connector, carry out an engine diagnosis.
With OBD model
Without OBD model

26. STARTING CONDITION

Start the engine and check that the engine starts
smoothly. If any battery voltage problems are
found, recharge or replace the battery. If any
abnormal noises are observed, immediately stop
the engine and check and repair the necessary
components.

27. EXHAUST SYSTEM

Listen to the exhaust noise to see if no abnormal
noises are observed.

28. INDICATOR LIGHT

Check that all the indicator lights are off.
29. CLOCK
SA09719G5032
Check the clock for normal operations and enough
accuracy.
PRE-DELIVERY INSPECTION
GI0095A
GI0119A
SA09719G5029
SA09719G5030
SA09719G5031
PI-9

30. RADIO

SA09719G5033
Check the radio for full functionality and normal
noise level. Also check the CD unit operations.
31. CIGARETTE LIGHTER
Check that the cigarette lighter operations.
32. LIGHTING SYSTEM
¼ Check the headlight operations.
¼ Check the brake light operations.
¼ Check the other lights for normal operations.
33. WINDOW WASHER
Check that the window washer system injects
washer fluid to the specified area of the windshield
shown in the figure.
34. WIPER
SA09719G5037
Check the front and rear wipers for normal opera-
tions.
35. BRAKE TEST
SA09719G5038
Check the foot brake for normal operations.
36. PARKING BRAKE
Check the parking brake for normal operations.
Pre-delivery Inspection
SA09719G5034
SA09719G5035
SA09719G5036
GI0118A
SA09719G5039