Table of Contents
Advertisement
Adjusting the sound parameters for the
Surround/DSP modes
You can adjust the Surround/DSP sound parameters to your
preference.
• For details about the Surround/DSP modes, see pages 38 to 43.
7 Adjusting the effect level for DSP modes
—EFFECT
This setting is available only when one of the DSP modes (except
ALL CH ST) is in use. To activate DSP mode, see page 42.
• Once you have made an adjustment, it is memorized for each
DSP mode.
Adjustable range: 1 to 5 (in 1 step intervals)
Initial setting: EFFECT: 3
As the number increases, the effect becomes stronger.
Normally, select "3."
From the remote control:
You can also make adjustments the following way from the
remote control.
Set the mode selector to "AUDIO/TV/VCR/STB."
Press SOUND, then press EFFECT
repeatedly.
NOTE
After pressing SOUND, the numeric
buttons work for sound adjustments. To
use the numeric buttons to operate your
target source, press the corresponding
source selecting button before operation;
otherwise, the remote control may not
work as you intend.
7 Adjusting the panorama control for Pro Logic II
Music—PANORAMA
This setting is available only when Pro Logic II Music is in use. To
activate Pro Logic II Music, see page 42.
• Once you have made an adjustment, it is memorized until you
change the setting.
PANORAMA: ON
Select to add "wraparound" sound effect with
side-wall image.
PANORAMA: OFF Select to listen to originally recorded sound.
Initial setting: PANORAMA: OFF
7 Making the center tone soft or sharp
—CENTER TONE
This setting is available when one of the Surround/DSP modes is
in use. To activate Surround/DSP mode, see page 42.
• This setting is common to all Surround modes, and is
memorized separately for DSP modes.
• You cannot adjust the center tone in the following cases:
– When "CENTER SPEAKER" is set to "CENTER SPK: NO"
(see page 21).
– When Dual Mono software is played back.
– While listening with the headphones.
Adjustable range: 1 to 5 (in 1 step intervals)
Initial setting: CENTER TONE: 3
As the number increases, the dialogue becomes stronger.
Normally, select "3."
• When the center tone is set to other than "CENTER TONE: 3,"
the C.TONE indicator lights up on the display.
From the remote control:
You can also make adjustments the following way from the
remote control.
Set the mode selector to "AUDIO/TV/VCR/STB."
Press SOUND, then press C.TONE
repeatedly.
NOTE
After pressing SOUND, the numeric
buttons work for sound adjustments. To
use the numeric buttons to operate your
target source, press the corresponding
source selecting button before operation;
otherwise, the remote control may not
work as you intend.
7 Align the vertical localization of the center
channel —CENTER ALIGNMENT
This setting is available when one of the Surround/DSP modes
(except "PLII MUSIC" and "ALL CH ST") is in use. To activate
Surround/DSP mode, see page 42.
• Once you have made an adjustment, it is memorized for each
Surround/DSP mode.
• You cannot adjust the center alignment in the following cases:
– When "CENTER SPEAKER" is set to "CENTER SPK: NO"
(see page 21).
– When Dual Mono software is played back.
– While listening with the headphones.
C ALIGNMENT: ON Select when you cannot feel as if the actors
or singers are speaking or singing on the
screen.
C ALIGNMENT: OFF Select not to use this function.
Initial setting: C ALIGNMENT: OFF
31
Advertisement
Table of Contents
