Adjusting Dsp Sound Parameters - JVC TH-45 Instructions Manual

Creating Realistic Sound Fields
REW
VCR CHANNEL
B.SEARCH
2 3
DVD FM/AM
1
4
7
SLOW
ANGLE ZOOM
REPEAT A-B REPEAT
CLEAR SEARCH
4
To adjust the output level for the rear speakers
1) Press SOUND repeatedly until "REAR"
appears on the display.
• Each time you press the button, the indication on
the display changes as follows:
00 F 00
Normal
REVERB
indication
(canceled)
REAR : To adjust the output level for rear speakers
(from –06 dB to +06 dB).
• "REAR –06dB" is the initial setting. If you have already
changed the setting, another value will appear.
2) Press 3 or 2 to adjust the output level.
3 : Increases the output level.
2 : Decreases the output level.
5
To adjust the overall level of DSP effect
Press EFFECT repeatedly to adjust the overall
level.
"EFFECT (with the current setting)" or "DEFAULT" appears on
the display.
• Each time you press the button, the effect level changes as
follows:
EFFECT 1
DEFAULT
As the number increases, DSP effect becomes stronger.
• "DEFAULT" is the initial setting. For in-depth information
about "DEFAULT (initial)" setting, see the table to the right.
24
FF
TUNING
F.SEARCH
ENTER
VOLUME
AUX MUTING
SOUND
SOUND
2 3
SETTING
5 6
PRO LOGIC
8 9
SETUP TEST
0
DSP MODE
D.R.C DSP MODE
EFFECT
PROGRAM EFFECT
REMAIN SLEEP
SOUND
00 R 00 REAR
LIVE ROOM
EFFECT
EFFECT 2
EFFECT 3

Adjusting DSP Sound Parameters

You can fine-adjust DSP modes more minutely by changing three
parameters—room, liveness, and reverberation.
Before you start, remember...
• There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
1
Press DSP MODE (or DSP on the front
panel) repeatedly to select the desired
DSP mode.
2
Press SOUND repeatedly to select the
desired DSP sound parameter.
• Each time you press the button, the indication on the
display changes as follows:
00 F 00
Normal
REVERB
indication
(canceled)
ROOM : To adjust the resonance based on the room size.
The larger this value is, the more effective the
resonance is (from 04 to 16 by 2 steps).
LIVE (Liveness) : To adjust the liveness. The larger this
value is, the more liveness is obtained (from 04 to
16 by 2 steps).
REVERB (Reverberation) : To adjust the reverberation
time of the sound (from 0.0 msec to 1.6 msec by
0.2 msec steps).
• The following diagram shows the "DEFAULT (initial)"
settings of the DSP sound parameters for each DSP mode.
DSP MODE
HALL
THEATER
PAVILION
DANCE CLUB
LIVE CLUB
3
Press 3 or 2 to adjust the DSP sound parameter.
3 : Increases the value.
2 : Decreases the value.
4
Repeat 2 and 3 for setting the other DSP sound
parameters.
Note:
Pressing EFFECT to adjust overall level of DSP effect will change
your fine-adjustments to the fixed level.
DSP MODE
SOUND
00 R 00 REAR
LIVE ROOM
ROOM LIVE REVERB
08 16 0.4
04 10 1.0
08 04 0.2
04 08 1.6
08 16 1.4