JVC LVT1306-007A Instructions Manual page 46

From the remote control:
1
When operating the receiver using
the remote control, set the mode
selector to "AUDIO/TV/VCR/STB."
2
1
Select and play any source other than "DVD
MULTI."
• Make sure you have selected the input mode (analogue or
digital) correctly.
2
Press SURROUND repeatedly to select the
Surround/DSP mode you want.
Ex.: When "DOLBY D" is selected for Dolby Digital multi-
channel software:
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST
LPCM L C R PL
DOLBY D NEO : 6
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
AUTO SURR
HALL1
LIVE CLUB
PAVILION
THEATRE2
ALL CH ST
(Back to the beginning)
To cancel Surround/DSP modes
Press SURROUND repeatedly so that "SURR OFF" appears on
the display.
42
AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
Surround modes*
HALL2
DANCE CLUB
THEATRE1
MONO FILM
SURR OFF
On the front panel:
2
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 2 again.
1
Select and play any source other than "DVD
MULTI."
• Make sure you have selected the input mode (analogue or
digital) correctly.
2
Press SURROUND.
MULTI JOG now works for selecting Surround/DSP modes.
3
Turn MULTI JOG to select the Surround/DSP
mode you want.
Ex.: When "DOLBY D" is selected for Dolby Digital multi-
channel software:
EQ C.TONE VIRTUAL SB AUDIO P. BASS TA NEWS INFO RDS TUNED ST
LPCM L C R PL
DOLBY D NEO : 6
S . WFR LFE
DTS AAC DSP 3D
LS SB RS
96 / 24 AUTO SR
AUTO SURR
HALL1
LIVE CLUB
PAVILION
THEATRE2
ALL CH ST
(Back to the beginning)
To cancel Surround/DSP modes
Turn MULTI JOG so that "SURR OFF" appears on the display.
NOTE
The initial setting is "AUTO SURR."
* Available Surround modes vary depending on the incoming
signals. For details, see "Available Surround and DSP modes
according to the incoming signal" on page 43.
1, 3
AUTO MUTING SLEEP AUTO MODE
ATT
HP
MHz
kHz
Surround modes*
HALL2
DANCE CLUB
THEATRE1
MONO FILM
SURR OFF