Service Aids; Test Equipment - Motorola CDM-Series Service & Installation Manual

CDM Control Station

Service Aids

The following table lists service aids recommended for working on the CDM Control Station.
Motorola Part No.
HLN9214
HSN9412
HKN9216
HKN9217
HVN9025

Test Equipment

The following table lists test equipment required to service the CDM Control Station.
Motorola Model No.
R2200, R2400, or R2001
*R1049
*S1100
*S1053, *SKN6009,
*SKN6001
R1053
*S1350, *ST1215 (VHF)
*ST1223 (UHF) *T1013
S1339
*R1013
S1347 or
S1348 (prog)
October, 2004
Description
Radio Interface Box
RIB Power supply
Computer Interface cable
Program Test Cable
CDM-Series CPS
Description
Service Monitor This monitor will substitute
for items with an
asterisk *
Digital Multimeter
Audio Oscillator 67 to 200 Hz tones
AC Voltmeter, Power Ca- 1mV to 300V, 10-Megohm in-
ble for meter, Test leads for put impedance
meter
Dual-trace Oscilloscope 20 MHz bandwidth,
5mV/cm - 20V/cm
50 Ohm, ±5% accuracy,
Wattmeter, Plug-in
Elements (VHF & UHF), 100 Watts, maximum
RF Dummy Load 0-1000 MHz, 300 Watts
RF Millivolt Meter 100uV to 3V RF, 10 kHz to
1.2 GHz
SINAD Meter
DC Power Supply 0-20 Vdc, 0-5 Amps
Enables communication between the radio and the computer's serial
communications adapter.
Used to supply power to the RIB.
Connects the computer's serial communications adapter to the RIB.
RIB to Radio Cable
Software on 3-1/2 in. diskettes.
Characteristics
Frequency/deviation meter and signal genera-
tor for wide-range troubleshooting and align-
ment
Two meters recommended for ac/dc voltage
and current measurements
Used with service monitor for injection of PL
tones
Audio voltage measurements
Waveform measurements
Transmitter power output measurements
RF level measurements
Receiver sensitivity
Bench supply for 12.5 Vdc
6880309N15-A
Service Aids
Application
Application
Foreword
v