See Fig - JVC MX-DVA9 Service Manual

MX-DVA9/MX-DVA9R
Removing the actuator motor boad
1. Absord the four soldered positions "M" of the right and
left motors with a soldering absorber(See Fig.14).
2. Remove the two screws 7 retaining the actuator motor
board(See Fig.14).
3. Remove the two screws 8 retaining the tray select
switch board(See Fig.15).
Removing the can unit
1. Remove the CD mechanism assembly.
2. While turning the cam gear L, align the pawl "N"
position of the drive unit to the notch position(Fig.15) on
the cam gear L.
3. Pull out the drive unit and cylinder gear(See Fig.17).
4. While turning the cam gear L, align the pawl "O"
position of the select lever to the notch position(Fig.18)
on the cam gear L.
5. Remove the four screws 9 retaining the cam unit(cam
gear L and cams R1/R2 assembly)(See Fig.18).
Chassis assembly
CN801
1-22

(See Fig.14, 15)

(See Fig.15~18 )
Tray select
switch board
CN802
Fig.15
Drive unit
Cylinder gear
Fig.17
M
Actuator motor board
Drive unit
N
8
CN804
9
Cam gear L
9
O
Motor L
7
Motor R
Fig.14
Cam gear L
Fig.16
Cams R1, R2 assembly
Cam unit
Select lever
Fig.18
M
7
9