JVC MX-DVA9 Service Manual page 19

DVD Changer Mechanism Section
Removing the DVD Servo control
board
1. Remove the Metal cover.
2. Remove the DVD changer mechanism assembly.
3. From bottom side the DVD changer mechanism
assembly, remove the one screw 1 retaining the DVD
Servo control board.
4. Ciconnect the card wire,From the connectors CN101
and CN102, on the DVD Servo control board.
5. Disengage the two engagements "A" , remove the DVD
Servo control board.
Removing the DVD tray assembly
1. Remove the front panel assembly.
2. Remove the DVD changer mechanism assembly.
3. Remove the DVD Servo control board.
4. Remove the screw 2 retaining the Disc stopper
5. Remove the three screws 3 retaining the T.bracket
6. From the clamper base section "C" , remove both of the
edges fixing the rod(See Fig.2 and 3).
7. Remove the screw 4 retaining the clamper assembly
8. From the left side face of the chassis assembly, remove
the one screw 5 retaining both of the return spring and
lock lever(See Fig. 4).
9. By removing the pawl at the section "D" fixing the return
spring, dismount the return spring(See Fig.4).
10. Remove the three lock levers(See Fig.4).
T.Braket
3
B
C
Clamper ass'y
Fig.3
(See Fig.2~4)
(See Fig.3).
(See Fig.3).
(See Fig.3).
Disc stopper
2
3
Lod stopper
(C/J version only)
3
4
DVD servo control baord
CN102
CN101
A
Fig.1
B
Rod
T.Braket
Fig.2
Lock lever
Fig.4
MX-DVA9/MX-DVA9R
1
A
Clamper base
C
D
Return spring
5
1-19