JVC MX-DVA9 Service Manual page 10

MX-DVA9/MX-DVA9R
Removing the tuner board
Prior to performing the following procedure, remove
the metal cover.
1. Disconnect the card wire from connector CN1 on the
tuner board on the right side of the body.
2. Remove the plastic rivet fixing the tuner board.
3. Remove the two screws F on the back of the body.
CAUTION: When reassembling, connect the earth
terminal which is extending from the
DVD changer mechanism assembly and
attached to the tuner board, to the inner
side of the rear panel.
Removing the rear cover / rear panel
Prior to performing the following procedure, remove
the metal cover and the DVD changer mechanism
assembly, the tuner board.
1. Remove the screw G attaching the rear cover on the
back of the body.
2. Push each tab of the four joints b in the direction of
the arrow and release.
3. Remove the fourteen (A/B/EN) or sixteen(US/UJ/UG/
UN/UW) screws F attaching the rear panel.
4. Disengage the joints c on each lower side of the rear
panel using a screwdriver and remove the rear panel
backward.
Joint c
Rear panel
Fig.17
1-10
(See Fig.13 and 14)
(See Fig.15 to 17)
Rear panel
Fig.16
CN1
Plastic rivet
Fig.13
Joints b
Rear cover
Fig.14
F
F
F
F
F
F
Joint c
Tuner board
Rear panel
F
G
Rear panel
Joints b
Rear panel
F
F
Fig.15-1
Rear panel
F
F F
Fig.15-2
F