Table of Contents
Advertisement
3.2.1 System Configuration
The switch supports manual IP address setting. When IP address is changed, you must reboot the
switch to have the setting taken effect and use the new IP to browse for web management.
Parameter description:
MAC Address
Firmware Version
Hardware Version
Serial Number
IP Address
Subnet Mask
Default Gateway
System Name
Password
Auto Logout Timer
It is the Ethernet MAC address of the management agent in this switch.
The firmware version of this switch.
The hardware version of this switch.
The serial number is assigned by the manufacturer.
Users can configure the IP settings and fill in new values. Default:
192.168.1.1
Subnet mask is used to set the subnet mask value. Default: 255.255.255.0
Set an IP address for a gateway to handle those packets that do not meet
the routing rules predefined in the device. Default: 192.168.1.254
Set a special name for this switch. Up to 16 characters are allowed in this
parameter. Any alphanumeric character and null are acceptable. Default:
Giga Switch
Set a password for this switch. Up to 16 characters are allowed in this
parameter. Any alphanumeric character is acceptable. Default: admin
Set the auto-logout timer. The valid value is 0 ~ 60 in the unit of minute
and a decimal point is not allowed. The value 0 means auto-logout timer is
disabled. Default: 0
-15-
Advertisement
Table of Contents
