To Turn The Unit 'Off; Adjusting The Temperature - Rinnai Energysaver RHFE-556FTR Operation And Installation Manual

To Turn the Unit 'OFF'

• Press the ON/OFF button to switch off the heater.
• The ON / Combustion indicator will go out.
• After the indicator has gone out, the convection fan will continue to rotate for several minutes, then
stop. This is to lower the temperature within the unit. DO NOT pull out the power cord during this
time.
• DO NOT pull out the power cord or disconnect the power during combustion to
cause extinction, or straight after extinction, as this may cause damage to the
unit.
CAUTION
• When the Function Lock is set, the Function Lock indicator will continue to
illuminate even when the unit is OFF and the Function Lock will not be
cancelled.
NOTE

Adjusting the Temperature

Displaying, setting and adjusting the room temperature can only be done when the unit is operating.
• When the unit is first operated, the room temperture is set at 22°C.
• Set the desired room temperature will the up and down buttons while looking at the display section.
• The "Set Temp" can be set to "L" or between "16" ~ "26", or "H" (continuous combustion on High).
• The "Room Temp" will display "L" (when lower than 1°C), "1" ~ "30" (at intervals of 1°C), or "H"
(when higher than 30°C).
• Once a temperature is set, it will be stored in the microcomputer's memory.
• Rooms may not arrive at the set temperature due to the construction of the
room, the location of the unit, or external temperatures.
NOTE
• If the heater does not ignite then the pre-set temperature may not be set to a
setting which is higher than the actual room temperature. The ON indicator will
change colour from red to green when the heater reaches the pre-set
temperature and stops running. The heater will operate at eight minute intervals
to maintain warmth in a room.
Rinnai Australia
1
17 Energysaver® - Operation & Installation Manual