Removing The Terminal Covers - JVC LT-26D50BJ Instructions Manual

LT-32&26D50BJSJ_Eng.book Page 8 Thursday, October 7, 2004 4:42 PM
Setting up your TV
Cable holder
A cable holder which is used to keep the
connection cables tidy is attached to the back
of the stand. Gently squeeze the left and right
of the cable holder and pull it to remove it from
the stand. After putting the cables in the cable
holder, attach it to the back of the stand again.

Removing the terminal covers

There are connection terminals behind the covers on the left and right of the rear of the TV.
Remove these two covers before connecting an antenna or VCR.
Remove the covers by removing the hooks.
When replacing the covers, place the side of
the covers against the TV and insert the hooks.
• Leave the covers off if they do not fit properly. Do not force to replace the covers. Doing so
may cause damage to the connection cables and the covers.
8
LT-32/26D50BJ/SJ / LCT1703-001B-U / ENGLISH
cable holder