Section Xiv - Maintenance Procedures; Maintenance Procedures; Reported Problems; Check Surrounding Area - Prestige Solo 175 Installation And Maintenance Manual

Maintenance Procedures

SECTION XIV - Maintenance
Procedures
Maintenance Procedures
WARNING
The PRESTIGE
and serviced annually, preferably at the
start of the heating season, by a qualified
service technician.
maintenance and care of the unit as out-
lined on page 54 and further explained
on pages 55 through 59 should be per-
formed to assure maximum efficiency
and reliability of the unit. Failure to ser-
vice and maintain the PRESTIGE and
the system components could result in
equipment failure, causing possible
severe personal injury, death or substan-
tial property damage.
NOTICE
The following information provides
detailed instruction for completing the
maintenance items outline in the mainte-
nance schedule on page 53. In addition
to this maintenance, the PRESTIGE
should be serviced at the beginning of
the heating season by a qualified service
technician.

Reported Problems

Any problems reported by the owner should be
checked, verified and corrected before pro-
ceeding with any maintenance procedures.

Check Surrounding Area

Verify that the area surrounding the PRES-
TIGE is free of combustible / flammable mate-
rials or flammable vapors or liquids. Remove
immediately if found.
should be inspected
In addition, the
Verify that combustion air inlet area is free of
any contaminates. Refer to the list of potential
materials listed on page 5 of this manual. If
any of these products are in the area from
which the unit takes its combustion air, they
must be removed immediately or the combus-
tion air intake must be relocated to another
area.

Inspect Burner Area

Remove the boiler front jacket panel and ven-
turi inlet elbow.
Vacuum any dirt or debris from the
burner/blower components.
Re-install venturi inlet elbow and front jacket
panel when completed.
WARNING
Do not use solvents to clean any of the
burner components.
could be damaged, resulting in unreli-
able or unsafe operation.

Check System Piping

Inspect all piping (water and gas) on the boiler
system for leaks and verify that the piping is
leak free and properly supported.
Inspect the fittings and components on the unit
and verify they are leak free.
WARNING
Eliminate all boiler water system leaks.
Continual fresh make-up water will
reduce the heat exchanger life causing
boiler failure. Leaking water may also
cause severe property damage to the sur-
rounding area. Inspect the gas supply
piping using the procedure outlined on
Page 41.
55
The components