Step 1: Configuring The Client-To-Gateway Vpn Tunnel On The Dg834 - NETGEAR DG834 Reference Manual

Reference Manual for the ADSL Firewall Router DG834
• "Step 2: Configuring the NETGEAR ProSafe VPN Client on the Remote PC" on page 7-11
configures the NETGEAR ProSafe VPN Client endpoint.
22.23.24.25
DG834
192.168.3.1
PCs
Figure 7-3
Step 1: Configuring the Client-to-Gateway VPN Tunnel on the
DG834
Note: This section uses the VPN Wizard to set up the VPN tunnel using the VPNC
default parameters listed in
not covered by these VPNC-recommended parameters, refer to
VPN Tunnels in Special Circumstances" on page 7-35
The worksheet below identifies the parameters used in the following procedure. A blank
worksheet is at "Planning a VPN" on page
7-6
VPN Tunnel
Table 7-2 on page
7-3.
Virtual Private Networking (Advanced Feature)
v2.0, September 2005
0.0.0.0
PC
(Running NETGEAR
ProSafe VPN Client)
7-4. If you have special requirements
"How to Set Up
to set up the VPN tunnel.