Brother MFC-J5910DW Quick Setup Manual page 2

2
Load plain A4 paper
a
Pull the paper tray completely out of the
machine.
b
Open the output paper tray cover.
c
With both hands, gently press and slide the
paper length guide a and then the paper side
guides b to fit the paper size.
Make sure that the triangular marks c on the
paper length guide a and paper side guides b
line up with the mark for the paper size you are
using.
2
3
L Photo 2L EXE
4×6in
10×15cm
B5 JIS
d
Fan the stack of paper well to avoid paper jams
and misfeeds.
Note
Always make sure that the paper is not curled or
wrinkled.
2
B5
JIS
EXE
1
LTR
A4
3
LTR LGR
LGL
A4 B4 JIS
e
Check that the paper is flat in the tray.
IMPORTANT
Be careful that you do not push the paper in
too far; it may lift at the back of the tray and
cause paper feed problems.
f
Gently adjust the paper side guides to the
paper with both hands.
g
Close the output paper tray cover. Check that
the paper is flat in the tray and below the
maximum paper mark.
h
Slowly push the paper tray completely into the
machine.
i
While holding the paper tray in place, pull out
the paper support until it clicks, and then unfold
the paper support flap.