After Sales Service - Miele G 7859 Operating Instructions Manual

Water in the wash cabinet is not
heated; the program sequence lasts
too long
This machine has a resettable heater
limiter which will switch off the heaters
in the case of over-heating. This could
be caused for example, if large articles
obscure the heating elements or if the
filters in the wash cabinet are blocked.
^ Remove the cause of the fault.
^ Take off the service panel (see
"Electrical connection").
^ Press the reset button on the heater
limiter (yellow) located on the left-
hand side of the plastic cover.
If this switch trips again, the Miele
Service Dept. must be contacted.
Correcting minor faults

After Sales Service

Should you still have any difficulties or if
the fault code "F..." shows in the display
please contact your authorized Service
Dealer or the Miele Service
Department.
See back cover for addresses.
^ Please quote the fault code "F..." as
well as the model type and number of
your machine.
This information can be found on the
data plate inside the door (see also
"Electrical connection").
Please note that telephone calls may
be monitored and recorded to
improve our service.
43