Odu,Enable,1:1,Csat#1,Config,Receiver) Lna (Odu,Enable,1:1,Csat#2,Config,Receiver) Lna (Odu,Enable,Stand- Alone,Config,Receiver) Lna; (Odu,Enable,1:1,Csat#1,Config,Receiver,Lna) State; (Odu,Enable,1:1,Csat#2,Config,Receiver,Lna) State; Odu,Enable,1:1,Csat#1,Config,Receiver,Lna) Cal (Calibrate) - Comtech EF Data RAP-100 Installation And Operation Manual

ODU Operation
3.2.25 (ODU,ENABLE,1:1,CSAT#1,CONFIG,RECEIVER)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,RECEIVER)
(ODU,ENABLE,STAND-ALONE,CONFIG,RECEIVER) LNA
The user is prompted to select 1 of 4 selection using the LEFT/RIGHT arrow keys, then
to press ENTER.
3.2.26 (ODU,ENABLE,1:1,CSAT#1,CONFIG,RECEIVER,LNA)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,RECEIVER,LNA)
(ODU,ENABLE,STAND-ALONE,CONFIG,RECEIVER,LNA)
The user is prompted to select either ON or OFF, using the LEFT/RIGHT arrow keys,
then to press ENTER. This controls whether or not the CSAT will provide LNA
POWER via the Receive RF Cable.
3.2.27 (ODU,ENABLE,1:1,CSAT#1,CONFIG,RECEIVER,LNA)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,RECEIVER,LNA)
(ODU,ENABLE,STAND-ALONE,CONFIG,RECEIVER,LNA)
The user is prompted to select either CAL or EXIT, using the LEFT/RIGHT arrow keys,
then to press ENTER. This provides a means to calibrate the LNA current for use with
the Current-Window function described below.
3.2.28 (ODU,ENABLE,1:1,CSAT#1,CONFIG,RECEIVER,LNA)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,RECEIVER,LNA)
(ODU,ENABLE,STAND-ALONE,CONFIG,RECEIVER,LNA)
The user is prompted to edit the Current Window setting using the UP/Down arrow keys,
then to press ENTER. The value will scroll between 20% and 50% to define the
allowable LNA current change before declaring a fault. Selecting 99% disables the
current window function.
3–8
SELECT LNA: STATE
CURR-WINDOW FAULT-LOGIC
SELECT ODU LNA STATE:
ON OFF (PRESS ENTER)
CALIBRATE LNA CURRENT?
CAL EXIT (PRESS ENTER)
EDIT LNA CURRENT WINDOW:
99 % (PRESS ENTER)
LNA
LNA
CAL
RAP-100 Remote Access Panel
STATE
STATE
STATE
CAL (Calibrate)
CAL (Calibrate)
CAL (Calibrate)
CURR-WINDOW
CURR-WINDOW
CURR-WINDOW
Rev. 1