(Odu,Enable,1:1,Csat#1,Config,Transmitter) Frequency; (Odu,Enable,1:1,Csat#2,Config,Transmitter) Frequency; Odu,Enable,1:1,Csat#1,Config,Transmitter) Atten (Attenuation); (Odu,Enable,1:1,Csat#2,Config,Transmitter) Atten (Attenuation) - Comtech EF Data RAP-100 Installation And Operation Manual

RAP-100 Remote Access Panel
3.2.13 (ODU,ENABLE,1:1,CSAT#1,CONFIG,TRANSMITTER)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,TRANSMITTER)
(ODU,ENABLE,STAND-ALONE,CONFIG,TRANSMITTER)
The user is prompted to edit the transmit frequency. This is accomplished by selecting
the digit to be edited, using the LEFT/RIGHT arrow keys. The value of the digit is then
changed using the UP/DOWN arrow keys. The user then press ENTER.
3.2.14 (ODU,ENABLE,1:1,CSAT#1,CONFIG,TRANSMITTER)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,TRANSMITTER)
(ODU,ENABLE,STAND-ALONE,CONFIG,TRANSMITTER)
The user is prompted to edit the transmit attentuation. This is accomplished by selecting
the digit to be edited, using the LEFT/RIGHT arrow keys. The value of the digit is then
changed using the UP/DOWN arrow keys. The user then presses ENTER.
3.2.15 (ODU,ENABLE,1:1,CSAT#1,CONFIG,TRANSMITTER)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,TRANSMITTER)
(ODU,ENABLE,STAND-ALONE,CONFIG,TRANSMITTER)
The user is prompted to select either ON or OFF, using the LEFT/RIGHT arrow keys,
then to press ENTER.
3.2.16 (ODU,ENABLE,1:1,CSAT#1,CONFIG,TRANSMITTER)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,TRANSMITTER)
(ODU,ENABLE,STAND-ALONE,CONFIG,TRANSMITTER)
The user is prompted to select either MUTED or UNMUTED, using the LEFT/RIGHT
arrow keys, then to press ENTER.
Rev. 1
EDIT ODU TX FREQUENCY:
5912.5 MHz (PRESS ENT)
EDIT ODU TX ATTENUATION:
15.00 dB (PRESS ENTER)
SELECT ODU TX AMP STATE:
ON OFF (PRESS ENTER)
SELECT TX MUTE STATE:
MUTED UNMUTED (ENTER)
ODU Operation
FREQUENCY
FREQUENCY
FREQUENCY
ATTEN (Attenuation)
ATTEN (Attenuation)
ATTEN (Attenuation)
AMPLIFIER
AMPLIFIER
AMPLIFIER
MUTE
MUTE
MUTE
3–5