Table of Contents
Advertisement
ODU Operation
3.2.17
(ODU,ENABLE,1:1,CSAT#1,CONFIG,TRANSMITTER)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,TRANSMITTER)
(ODU,ENABLE,STAND-ALONE,CONFIG,TRANSMITTER)
The user is prompted to select either CALIBRATED or MANUAL, using the
LEFT/RIGHT arrow keys, then to press ENTER.
3.2.18
(ODU,ENABLE,1:1,CSAT#1,CONFIG,TRANSMITTER,SLOPE)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,TRANSMITTER,SLOPE)
(ODU,ENABLE,STAND-ALONE,CONFIG,TRANSMITTER,SLOPE)
If MANUAL mode is selected, the user is prompted to edit the transmit slope setting.
This is accomplished using the UP/DOWN arrow keys. The user then presses ENTER.
3.2.19
(ODU,ENABLE,1:1,CSAT#1,CONFIG)
(ODU,ENABLE,1:1,CSAT#2,CONFIG)
(ODU,ENABLE,STAND-ALONE,CONFIG)
This menu item is used to select which ODU Receivter parameter is to be modified. Use
the LEFT/RIGHT arrow keys, then press ENTER.
3.2.20
(ODU,ENABLE,1:1,CSAT#1,CONFIG,RECEIVER)
(ODU,ENABLE,1:1,CSAT#2,CONFIG,RECEIVER)
(ODU,ENABLE,STAND-ALONE,CONFIG,RECEIVER) FREQUENCY
The user is prompted to edit the receive frequency. This is accomplished by selecting the
digit to be edited, using the LEFT/RIGHT arrow keys. The value of the digit is then
changed using the UP/DOWN arrow keys. The user then press ENTER.
3–6
SELECT TX SLOPE MODE:
CALIBRATED
MANUAL (ENT)
EDIT ODU TX SLOPE:
0.0
(PRESS ENTER)
ODU RX: FREQUENCY
MUTE
SLOPE
EDIT ODU RX FREQUENCY:
3912.5 MHz
(PRESS ENT)
RECEIVER
RECEIVER
RECEIVER
ATTEN
LNA
RAP-100 Remote Access Panel
SLOPE
SLOPE
SLOPE
MANUAL
MANUAL
MANUAL
FREQUENCY
FREQUENCY
Rev. 1
Advertisement
Table of Contents
