Table of Contents
Advertisement
G
Enter the channel position.
Press PR +/–.
H
Set the tape speed.
Press SP/LP/EP (p).
Select the appropriate colour system with "PAL/MESECAM"
and "NTSC". (
pg. 77, 78)
I
Return to the normal screen.
Press PROG or OK. "PROGRAM COMPLETED" appears
on the TV screen for about 5 seconds, then the normal
screen appears. If "PROGRAM OVERLAPPED" appears
on the TV screen, see page 38.
Repeat steps B – I for each additional programme.
J
Engage the unit's timer mode.
Press # (TIMER). The unit turns off automatically and
"#" appears on the front display panel.
To disengage the timer mode, press # (TIMER) again.
To Timer-Record Weekly Or Daily Serials:
— anytime during steps D through H, press WEEKLY (number
key "9") for weekly serials or DAILY (number key "8") for daily
serials (Monday – Friday). Either "WEEKLY" or "DAILY" appears
on the TV screen. Pressing the button again makes the
corresponding indication disappear.
– P1 –
START
STOP
21:00
22:00
SP
DATE
TV PROG
25.12
1
[+/–]
[PROG] : EXIT
NOTE:
You can programme this unit to timer-record as many as 8
programmes. If you try to programme the unit to record a ninth,
"PROGRAM FULL" appears on the TV screen. To record the
extra programme, you must first cancel any unnecessary
programmes. (
pg. 37)
Satellite Receiver Users
To timer-record a satellite broadcast using Express Timer
Programming:
A Perform steps A – J. Enter "L-1" for the channel position
in step G.
B Set the satellite receiver to the appropriate channel before
the selected programme begins.
C Leave the satellite receiver's power on.
35
EN
Advertisement
Table of Contents
