Table of Contents
Advertisement
E
Select the TV system.
Press rt to place the pointer next to the appropriate TV
system (refer to the table below).
Major Countries/Areas
Australia, New Zealand, Kuwait, U.A.E.,
Indonesia, Singapore, Thailand,
Malaysia, Iran, Saudi Arabia, Egypt,
Morocco, Lebanon, Iraq
China, Mongolia, Russia
Hong Kong
F
Start Auto Channel Set
Press OK or e.
DO NOT press any button on the unit or remote control
while Auto Set Up is in progress.
Receivable channels in your area are automatically assigned to
the PR +/– buttons, and non-receivable channels are skipped.
As Auto Set Up progresses, the
"q" mark on the TV screen moves
from left to right.
When Auto Set Up is completed,
the lowest position number will
appear on the front display
panel. If "SCAN COMPLETED –
NO SIGNAL–" is displayed on
the TV screen, make sure that the
aerial cable is connected to the unit properly and press OK on
the remote control. The unit will try Auto Set Up again.
TV System
B/G
D/K
I
AUTO CH SET
PLEASE WAIT
START
FINISH
I I I I I I I I I I I I
– – – – – – –
NOTES:
If there is a power cut, or if you press 1 or SET UP MENU
while Auto Set Up is in progress, Auto Set Up will be
interrupted; be sure to turn off the unit power once and try
again from step A.
If no sound accompanies the picture or the audio sounds
unnatural on some channels that have been stored by Auto Set
Up, the TV system setting for those channels may be incorrect.
Select the appropriate TV system for those channels.
(
pg. 86, "TV System Selection — When you see the picture
but the audio can't be heard or sounds unnatural")
ATTENTION
If you perform Auto Set Up successfully during installation,
there's no need to separately perform the Clock Set or
Channel Set procedures, but if adjustments become
necessary, they can be performed as follows:
Tuner setting
pg. 83
Clock setting
pg. 87
After "Auto Set Up" is completed, perform "Monitor
Set (DVD deck)" on page 18.
17
EN
Advertisement
Table of Contents
