Editing (Vcr Deck); Edit From A Camcorder - JVC HR-XVC33UM Instructions Manual

Filename [XVC33UM_09Editing.fm]
XVC33UM_01.book Page 68 Monday, August 4, 2003 7:24 PM
68
EN
Edit From A
Camcorder
Recorder
AUDIO input
VIDEO
input
Audio/video cable
(not supplied)
To Audio/VIDEO
Output
connectors
Camcorder
To EDIT
Player
Page 68
You can use a camcorder as the source player and your
unit as the recording deck.
Slide the TV/VCR/DVD switch to the right.
A
Make connections.
Connect the camcorder's AUDIO OUT and VIDEO OUT
connectors to the unit's front panel AUDIO and VIDEO
input connectors.
When using a monaural camcorder, connect its AUDIO OUT
connector to the AUDIO L input connector on your unit.
When a Master Edit Control-equipped JVC camcorder is used,
the camcorder is capable of controlling the unit. Refer to the
camcorder's instruction manual for operating procedure.
You can also use the AUDIO/VIDEO INPUT connectors on the
rear panel.
B
Select the VCR deck.
On the unit
Press VCR/DVD repeatedly so that the VCR indicator
lights up.
On the Remote
Press VCR so that the VCR indicator lights up.
C
Set the unit's input mode.
Press AUX (number key "0") and/or CH to select "F-1" for
the front AUDIO/VIDEO input connectors, "L-1" for the
rear AUDIO/VIDEO INPUT connectors, depending on
the connectors being used.
D
Set the edit mode.
See "PICTURE CONTROL" on page 76.
E
Engage the Record Pause mode.
Use PLAY (4), REW (3), or FF (5) to locate the
point where you start recording, then press and hold
PAUSE (9) and press REC (7) to engage the Record Pause
mode.
F
To PAUSE
Start the camcorder.
connector
Engage the Play mode of the camcorder.
G
Mini-plug cable
Start the unit.
(not provided)
(JVC camcorder
Press PLAY (4) to engage the Record mode of the unit.
only)
NOTES:
All necessary cables can be obtained from your dealer.
When you select "EDIT" to dub tapes in step D, be sure to
select "NORM" after you finish dubbing the tapes.
Masterpage:Left0

EDITING (VCR DECK)

4 August 2003 6:50 pm