Use Stand Adapter; Mounting The Adapter To Plate; Screw-Mounting The Adapter; Using The Stand Adapter - VeriFone PINpad 1000SE Installation Manual

Use Stand
Adapter
Mounting the
Adapter to Plate
Screw-Mounting the
Adapter
Using the Stand
Adapter
The optional stand adapter holds the PINpad 1000
wall. The unit can be removed from the stand adapter for handheld operation.
Figure 5 shows how to install a stand adapter onto a pre-existing flat mounting
plate.
1
Select a location for the stand adapter on a smooth wall or countertop. Be sure
the cable can easily reach the controller from this position without stretching.
2
Position the keyholes on the molded cradle over the slotted screws on
mounting plate. Slide the adapter downward until the screws are in the narrow
ends of the keyholes.
Figure 5 Stand Adapter Installation
The stand adapter may also be screwed directly to a wall or countertop.
•
Use screw anchors when fastening the adapter to a cement or brick wall.
•
When fastening the plate to drywall, the screws must go into the studs behind
the wall. Screw anchors alone will not safely hold the adapter to drywall.
To screw-mount the stand adaptor, use American National Standard #8 or Metric
M3 screws, with head diameter between 4.5 and 6.0 mm, and head thickness less
than 2.5 mm. Use the stand adaptor to mark the hole placement on the desired
location, and then insert screws, adjusting the screw depth until the unit is firmly
mounted.
Figure 6 shows how to insert a PINpad 1000
of the PINpad 1000 into the bottom of the stand adapter, then press the screen
SE
end of the PINpad 1000
and feel the release lever click.
SE
firmly into the top of the stand adapter until you hear
SE
securely to a countertop or a
SE
into a stand adapter. Slide the end
PIN 1000 I
PAD SE NSTALLATION
S
ETUP

Use Stand Adapter

15
G
UIDE