Connect Via Usb - VeriFone PINpad 1000SE Installation Manual

S
ETUP

Connect via USB

Connect via
USB
CAUTION
NOTE
14
PIN 1000 I
PAD SE NSTALLATION
The USB version of the PINpad 1000
ECR, or a host PC using a coiled USB cable (VFN#WCL115002-A). When
connecting to a PC via a USB port, the device, in either PINpad 1000
or NURIT 222 mode – requires the additional installation of device drivers.
1
Connect the device to the host PC.
2
Wait until the host PC recognizes the new hardware and starts the Found New
Hardware Wizard.
3
Follow the instructions on the Found New Hardware Wizard to install the USB-
UART driver.
When connecting with USB, the PINpad 1000
connected directly to the terminal, ECR or host PC port, or to a powered USB hub.
If an extension cable is required, only USB-certified cables should be used.
Additional instructions and device drivers are found and downloaded from the
VeriFone Technical Support page
support.aspx).
Browse to the INF file provided by VeriFone when specifying the driver location.
When the installation is done, check the list of ports on the Device Manager to see
the new USB device.
G
UIDE
can also be connected to a terminal,
SE
USB cable should either be
SE
(http://www.verifone.com/technical-
PCI mode
SE