Connect Unit To Controller - VeriFone PINpad 1000SE Installation Manual

S
ETUP

Connect Unit to Controller

Connect Unit to
Controller
WARNING
NOTE
12
PIN 1000 I
PAD SE NSTALLATION
The PINpad 1000 rear panel has a modular, four-wire interface port for power
SE
and communication connection to the controller. The connection methods differ
between two specific versions of the PINpad 1000
section discusses a connection to the RS-232 version of the PINpad 1000
Turn off or unplug the controller when connecting or disconnecting the
PINpad 1000 . Memory corruption and data loss can result if the controller is
SE
processing data when power is removed.
Refer to the controller device instructions for any controller-specific warnings.
Figure 3 illustrates how to connect the PINpad 1000
other terminal or controller connections, refer to the reference manual for that
controller.
Figure 3 PINpad 1000
1
Disconnect power from the terminal or ECR.
2
Position the PINpad 1000
damaging the keypad or display.
3
Connect the modular plug on the cable to the modular jack on the rear of the
PINpad 1000 device.
SE
4
Connect the other end of the cable to the PlN pad port on the rear of the
terminal.
5
Reconnect power to the terminal.
For cable removal, use the same steps described above in reverse. If exchanging
cables, use a VeriFone-approved cable.
G
UIDE
SE
and Terminal Cable Connections
SE
face down on a soft, smooth surface to avoid
SE
– USB and RS-232. This
SE
x
to a V series terminal. For
SE
.