Satellite Receiver Control Setting (Dvd Deck Only) - JVC DR-MV1B Instructions Manual

Filename [DR-MV1SEK_04Name.fm]
DR-MV1SEK_00.book Page 23 Thursday, April 15, 2004 3:30 PM
Satellite Receiver Control Setting (DVD
Deck Only)
Your unit
Transmitter
Satellite Controller
(provided)
Satellite receiver
21-pin SCART cable
(provided)
Back of unit
2
SAT CONTROL
VCR/DVD
1 2
4 5
7 8
0
ENTER
SET UP
Page 23
Satellite receiver
Satellite Controller
(provided)
(suggested locations)
L-2 IN/DECODER
SAT
3
6
9
rtw e
The following procedure is required if you receive satellite channels
through a satellite receiver. Approximately 20 seconds before the
VIDEO Plus+ Timer Programming (
programming ( pg. 46) starts, the unit sets its input mode to "L-2"
and automatically switches the satellite receiver's channels using a
provided Satellite Controller.
Installing Satellite Controller
1
Place a Satellite Controller so that the path between its
transmitter and the satellite receiver's remote sensor is
unobstructed.
2
Fix securely using the adhesive strip attached on the back of the
Satellite Controller.
3
Be sure to connect the unit's L-2 IN/DECODER connector to the
satellite receiver's 21-pin SCART connector.
NOTE:
When connecting your satellite receiver, refer to its instruction manual.
4
Connect the Satellite Controller to the SAT CONTROL
connector on the rear panel.
Setting Satellite Receiver's Brand And Channel
After installation, set the satellite receiver's brand and channel
correctly; otherwise, the Satellite Controller cannot work correctly.
Turn on the unit.
Turn on the TV and select the AV mode.
Slide the TV/CABLE/SAT/DVD switch to DVD.
1
Turn on the satellite receiver's power.
2
Press SET UP to access the Main Menu screen.
3
Press w e to select "INITIAL SET UP", then press ENTER.
4
Press w e to select "SAT/
GUIDE PR", then press ENTER.
5
Press rt to select "SAT
BRAND", then press ENTER.
6
Press rt to select the brand
code from the list on page 24,
then press ENTER.
If the brand code you entered is
invalid, the code field will be reset.
Enter the correct brand code again.
If the unit is in playback or recording mode, you cannot set the brand
code.
7
Press the appropriate number
keys to enter one of the channel
positions on the satellite receiver,
then press ENTER twice. The unit
enters the Test mode.
You can select the channel
position between 1 to 999.
Masterpage:Right+
INITIAL SETTINGS
23
EN
pg. 45) or Manual Timer
CONTINUED ON NEXT PAGE
April 15, 2004 3:19 pm