JVC DR-MV1B Instructions Manual page 94

Filename [DR-MV1SEK_10Subsidiary.fm]
DR-MV1SEK_00.book Page 94 Thursday, April 15, 2004 3:30 PM
TROUBLESHOOTING
94
EN
PlusCode NO. ERROR
CONFIRM PlusCode NO. THEN RETRY
An invalid PlusCode number has been input. (
GUIDE PROGRAMME IS NOT SET
SELECT CHANNEL YOU WANT TO RECORD
To set the timer programme using the VIDEO Plus+ system, the
Guide Program number must be set in advance. (
CAN NOT SET VIDEO Plus+ TIMER PROGRAMMING DURING
TIMER RECORDING OR INSTANT TIMER RECORDING
CANCEL TIMER RECORDING OR INSTANT TIMER RECORDING,
THEN ENTER THE PlusCode NO. AGAIN
Appears when you tried to input a PlusCode number during
timer recording or instant timer recording.
REGION CODE ERROR
CHECK DISC
A disc loaded cannot be played back on this unit since the region
number of the disc does not match that of the unit. (
UNREADABLE DISC
CHECK DISC
When an incompatible disc is loaded, 4 has been pressed.
( pg. 8)
COULD NOT FORMAT THE DISC
CHECK THE DISC
Formatting is not complete since the disc may be dirty or
damaged. Take out the disc, clean it and retry. (
COULD NOT FINALISE THE DISC
CHECK THE DISC
Finalising is not complete since the disc may be dirty or
damaged. Take out the disc, clean it and retry. (
COULD NOT CANCEL DISC FINALISATION
CHECK THE DISC
Cancelling disc finalisation is not complete since the disc may be
dirty or damaged. Take out the disc, clean it and retry. (
88)
PRESS [STOP] AGAIN TO STOP RECORDING
During Live Memory playback, 8 has been pressed. (
TIMER RECORDING COMPLETED
Timer recording has finished during Live Memory playback.
PLAYBACK WILL STOP
THEN TIMER RECORDING WILL START
Timer recording finished during Live Memory playback, then the
next timer recording is about to begin while playback continues.
COPY PROHIBITED
CAN NOT RECORD
An attempt has been made to record copy-protected contents.
An attempt has been made to record copy-once contents on a
disc that is not CPRM compatible, such as DVD-R.
Page 94
COPY PROHIBITED
CAN NOT PLAY
pg. 45) The unit has detected invalid contents at the start or in the
middle of playback.
THE i.LINK DEVICE THAT YOU HAVE CONNECTED IS NOT
RECOGNIZED
MAKE SURE THAT THE DEVICE IS CONNECTED PROPERLY AND
pg. 83)
POWERED ON
An attempt has been made to start DV dubbing when a digital
video camera is not properly connected to the unit.
Check the connection. (
pg. 8)
pg. 11, 87)
pg. 11, 88)
pg. 11,
pg. 34)
Masterpage:Left+
pg. 71)
April 15, 2004 3:21 pm