Table of Contents
Advertisement
S-VIDEO
Connection
(DVD deck only)
ATTENTION
Be sure to connect the unit's VIDEO OUTPUT (DVD/
VCR) connector to the TV's VIDEO input connector.
Antenna or Cable
Coaxial cable
Flat feeder
AC outlet
AC power
cord
Back of unit
S-Video cable
(not supplied)
To S-VIDEO input
connector
Matching transformer
(not supplied)
AUDIO OUTPUT
VIDEO OUTPUT
S VIDEO OUTPUT
VHF/
UHF IN
Audio/video
VHF/UHF
cable
(not supplied)
RF cable
(supplied)
To 75 ohm
Terminal
TV
8 To connect to a TV with S-VIDEO/AUDIO input
connectors . . .
A
Connect the unit to TV.
A Connect the antenna, unit and TV as per "AV
Connection" (
B Connect the unit's S VIDEO OUTPUT (DVD)
connector to the TV's S-VIDEO input connector.
B
Connect the unit to power source.
Plug the end of the AC power cord into an AC outlet.
C
Set the VCR channel to off.
Before performing the following steps:
● Make sure there is no cassette inserted in the unit.
● Make sure the unit is turned on, then press VCR/
DVD on the unit or VCR on the Remote so that the
VCR indicator lights up.
A When the unit is turned off, press STOP (8) on the unit
for more than 5 seconds. "3 CH" appears on the front
display panel.
B Press CH +/– on the Remote to select "– CH" (off),
then press ENTER.
● If Plug&Play or Tuner setting has not previously been
performed, the Language Select screen appears and Plug&Play
takes place automatically.
NOTES:
● You can obtain high-quality S-VIDEO pictures.
● If your TV is not stereo-capable, use the unit's AUDIO
OUTPUT connectors to connect to an audio amplifier for
Hi-Fi stereo sound reproduction.
● To operate the unit with your TV using the S-VIDEO
connection, set your TV to its AV mode. You can also use the
TV/VCR button on the unit's Remote to set JVC TV to the AV
mode.
● For switching the TV's mode, refer to the instruction manual of
your television.
● Only DVD picture is output from S-VIDEO OUTPUT
connector. (VCR picture is not output.)
OUT
pg. 12).
13
EN
Advertisement
Table of Contents
