Brother FAX4750 Service Manual page 77

(8) To take out the FU lamp from the heat-fixing unit, remove two screws "c."
(9) Unhook the two latches outwards (in the direction of arrows •) with the tip of a flat
screwdriver and open the upper cover (arrow ‚). The upper and lower covers will become
separated from each other.
(10) Loosen screw "d" (arrow ƒ).
(11) Remove screw "e," slightly lift up the heater roller gear (arrow „), hold the lock plate L of the
FU lamp between your fingers, and pull out the FU lamp from the heater roller (arrow ...).
CAUTION: Do not touch the FU lamp. If you have touched it, clean it thoroughly with
alcohol.
n n
Reassembling Notes
• When setting the FU lamp into the heat-fixing unit, be sure to insert the right edge of the wire
into the lock plate R as illustrated above.
IV - 32
"c": Taptite, cup B M3x20
"d": Pan cup M3x6
"e": Taptite, pan M3x10DB