Cancel Navigation discards the current route and exits Navigation Mode. This menu option will
only appear when you are currently navigating a route. This will not delete a previously-saved
route.
Active Side allows you to select a side of the screen in a Combo View. After you choose an
active side, you can apply menu settings and key commands to the view you've selected. The
Active Side menu option is only available when a Combo View is on the screen (see Views:
Combo Views).
• A green arrow on the Combo View points to the active side.
• When a menu is displayed in the active side, the non-active side of the screen will be
grayed out.
Split Position sets the size of the left side of the Combo View. Each Combo View can be set
individually. The Split Position menu option is only available when a Combo View is on the
screen (see Views: Combo Views).
• The number setting indicates the percentage taken up by the left side of the Combo
View.
• Selecting Left sets the left side of the screen to its smallest setting.
SI Side sets which transducer beam from the Side Imaging® beams will be shown on the display.
SI Sensitivity controls how much detail is shown on the display.
Increase the SI Sensitivity to reveal weaker returns that may be of interest, especially in very
clear water or greater depths. A high SI Sensitivity setting shows more sonar returns from small
baitfish and suspended debris in the water; however if the SI Sensitivity is adjusted too high,
the display may become too cluttered.
Side Imaging® X-Press™ Menu
Cancel Navigation
(only when Navigating)
Settings: Press the RIGHT Cursor key and follow screen instructions.
Active Side
(Combo Views only)
Settings: Left, Right; Default = Left
Split Position
(Combo Views only)
Settings: Left, 30, 40, 50, 60, 70, Right; Default = Various
SI Side
Settings: Left, Both, Right; Default = Both
SI Sensitivity
Settings: 1 to 20, where Low = 1, High = 20; Default = 10
110