Operation; Selecting Input Source - Pioneer PDP-505CMX Operating Instructions Manual

Operation

Selecting An Input Source
This section explains basic operation of this panel.
Outlined on the following pages is how to turn the main power
ON and OFF, how to operate the unit, when the unit should be
put in Standby mode, and how to select connected devices.
Before you begin, verify the following:
¶Check connections between the panel and the computer
as described in "Installation and Connections" starting
on page 10.
¶ Set up the on-screen menu to input signals from
devices connected to INPUT1 and INPUT2 as
described in "System Settings" starting on
page 16.
On-screen setup is not necessary if these terminals
are not being used.
STANDBY/
ON
INPUT
VOLUME
[+/–]
Main unit operating
panel
1
Set the rear panel MAIN POWER switch to ON.
The STANDBY indicator on the front panel lights red.
.
Press the STANDBY/ON button to turn power ON.
2
The ON indicator on the front panel lights green.
.
STANDBY/
ON
INPUT
VOLUME
[+/–]
Remote control unit
3
Press the INPUT button on the remote control unit
or the main unit to select the input.
Pressing the INPUT button causes the display to toggle
between the following options:
3 INPUT1
INPUT2 2
÷ When the menu screen is displayed, changing the
signal input caused the menu screen to turn OFF.
÷ If the input computer signal is not supported by the
display, the following message appears:
CAUTION
UNSUPPORTED SIGNAL
f H
f V
1
CAUTION
OUT OF RANGE
f H
f V
4
Use VOLUME (+/–) buttons on the remote control
unit or the main unit to adjust the sound volume.
If no audio connections are made to this unit, this step
is not necessary.
5
When viewing is finished, press the STANDBY/ON
button to put the unit in standby mode.
6
Set the rear panel MAIN POWER switch to OFF.
The STANDBY indicator may continue to light for a
short while even after the main power is turned OFF.
This is a result of residual electricity impressed on
the circuitry. The light turns off after a short period.
Note
Please do not leave the same picture displayed on the screen for
a long time. Doing so may cause a phenomenon known as
"screen burn" which leaves a ghost or residual image of the
picture on the screen.
INPUT1
:
8 6 . 7 k H z
:
8 8 . 5 H z
1 2 5 8 4 6
X
FULL
INPUT1
:
7 5 . 7 k H z
:
1 2 0 . 0 H z
– – – –
FULL
19
En