Settings After Connections - Pioneer PDP-505CMX Operating Instructions Manual

Settings after connections

On-screen setup is necessary when components are
connected to either INPUT1 or NPUT2.
The following instructions apply to common devices
connected to plasma panels.
[SIGNAL FORMAT] setup
Note:
These settings are required only when using the following input
signal refresh rates: 1 31.5 kHz horizontal / 60 Hz vertical; 2
48.4 kHz horizontal / 60 Hz vertical, or 56.1 kHz horizontal / 70 Hz
vertical; 3 64 kHz horizontal / 60 Hz vertical, 80 kHz horizontal /
75 Hz vertical, or 91.2 kHz horizontal / 85 Hz vertical. No manual
setup is necessary for signals with other refresh rates since
adjustments are performed automatically (the [SIGNAL FORMAT]
item is not displayed).
MENU
5/∞
2/3
SET
Main unit operating Remote control unit
panel
1
Press the MENU button to display the menu
screen.
MENU
PICTURE SCREEN
:
CONTRAST
:
BRIGHTNESS
:
R.LEVEL
:
G.LEVEL
:
B.LEVEL
:
H.ENHANCE
:
V.ENHANCE
PICTURE RESET
SET ENTER
2
Use the 2/3 buttons to select [SETUP].
MENU
PICTURE SCREEN
POWER MANAGEMENT
CLAMP POSITION
SIGNAL FORMAT
MENU
2/3
SET
5/∞
INPUT1
SETUP OPTION
0
0
0
0
0
0
0
MENU EXIT
INPUT1
SETUP OPTION
:
OFF
: AUTO
: V G A :
3 Use the 5/∞ buttons to select [SIGNAL FORMAT],
then press the SET button.
MENU
PICTURE SCREEN
POWER MANAGEMENT
CLAMP POSITION
SIGNAL FORMAT
4 Use the 2/3 buttons to select the display mode.
SIGNAL FORMAT
SET
S E T
1 When the input signal has a refresh rate of 31.5
kHz horizontal / 60 Hz vertical, pressing 2/3
causes the display mode to toggle between the
following options:
3 VGA 2
3 WVGA 2
2 When the input signal has a refresh rate of 48.4
kHz horizontal / 60 Hz vertical, or 56.1 kHz
horizontal / 70 Hz vertical, pressing 2/3 causes the
display mode to cycle through the following options:
3 PC AUTO 2
3 WXGA 2
3 When the input signal has a refresh rate of 64 kHz
horizontal / 60 Hz vertical, 80 kHz horizontal / 75 Hz
vertical, or 91.2 kHz horizontal / 85 Hz vertical,
pressing 2/3causes the display mode to toggle
between the following options:
3 SXGA 2
If the [PC AUTO] setting is selected when using the
above PC input signals, screen resolution automatically
switches between [XGA] and [WXGA].
Reminders
÷ The [PC AUTO] setting supports automatic signal selection
only when using separate RGB SYNC inputs.
÷ When G ON SYNC or Composite SYNC signals are input,
selecting [PC AUTO] causes the screen resolution to be set
to [XGA] only.
÷ When using G ON SYNC or Composite SYNC with WXGA
inputs, manually set the [SIGNAL FORMAT] to [WXGA].
5
Press the SET button.
The setting is stored in memory and the screen
returns to that shown in step 3.
6
When the setup is completed, press the MENU
button to exit the menu screen.
Note:
Set [SIGNAL FORMAT] for each input (INPUT1 and INPUT2).
.
System Settings
INPUT1
SETUP OPTION
:
OFF
:
AUTO
:
: V G A
:
VGA
EXIT
M N U
E
3 XGA 2
3 SXGA+ 2
17
En