Connection To A Personal Computer - Pioneer PDP-505CMX Operating Instructions Manual

Installation and Connections

Connection to a personal computer

Connection method differs depending on the computer
type. When connecting, please refer to the computer's
instruction manual.
Before connecting, verify that the computer's power and
the panel's power are OFF.
.
Connection to INPUT1
Connect the display's D-sub input connector to the
computer's D-sub output (analog RGB). This connector
also supports G ON SYNC (output with green signal
combined with sync signal), and composite SYNC
(output with combined horizontal and vertical sync
signals).
When connecting to ANALOG RGB IN (INPUT1)
INPUT1
ANALOG RGB IN ANALOG RGB OUT
D-Sub D-Sub
AUDIO
Connect the cable corresponding to the shape of the
panel's input terminal and to the computer's output
terminal. Secure by tightening the terminal screws
on both units.
To complete the installation, follow the on-screen setup.
See pages 16 to 18 for details.
Note:
Depending on the computer model being connected, a
conversion device or adapter (provided with the computer
or sold separately) may be necessary. For details, please
refer to the computer's instruction manual or consult
the computer maker or your nearest dealer.
NOTICE
¶ INPUT1 supports Microsoft "Plug & Play" (VESA DDC 1/2B)
components. See Appendix 2-1/2 (page 42) when using
INPUT1.
¶ See Appendix 1 (pages 38 and 40) for information regarding
signals and display formats supported by INPUT1.
12
En
When connecting to ANALOG RGB OUT (INPUT1)
INPUT1
ANALOG RGB IN ANALOG RGB OUT
D-Sub D-Sub
AUDIO
With this unit, it is possible to output the video signal to
an external monitor or other component through the
ANALOG RGB OUT (INPUT1) terminal.
Note:
A video signal is not output from the ANALOG RGB OUT
(INPUT1) terminal when the panel's power is OFF or in
Standby mode.
Connection to INPUT2
A computer equipped with DVI output (digital RGB signal)
can be connected to the video card's DVI connector.
INPUT2
DIGITAL RGB AUDIO
DVI-D
To complete the installation, follow the on-screen setup
See pages 16 to 18 for details.
Reminders
¶ Use a DVI-D 24-pin (digital only) cable for the connection.
¶ This unit does not support displaying copyguard-protected
video signals.
NOTICE
¶ INPUT2 supports Microsoft "Plug & Play" (VESA DDC 2B)
components. See Appendix 2-2/2 (page 42) when using
INPUT2.
¶ See Appendix 1 (pages 39 and 41) for information regarding
signals and display formats supported by INPUT2.
To an external monitor