Viewfinder Normal Indications - Sony CCU-TX50 Operating Instructions Manual

Viewfinder Normal Indications

During normal operation, the following items can be
indicated in the viewfinder.
1 VTR warning indication
2 VTR operation status
a), b), c)
indication
e)
3 Return video indication
a), b), c)
4 Time data indication
5 Status display area
6 Camera ID indication c)
c)
7 5600K indication
8 Filter setting indication c)
9 SKIN DTL indication c)
0 White balance indication
qa Gain indication c)
a) Displayed only when a DSR-1/1P is connected.
b) Displayed only when a PVV-3/3P is connected.
c) Whether or not to display can be selected by menu setting.
d) This is recorded over the picture being shot.
e) Displayed only when a CA-TX50/TX50P or CCU-TX50/TX50P is connected
The significance of each of the indications shown in
the figure is as follows.
1 VTR warning indication
This shows warning indications about operation or
status of the connected VTR.
When connecting the DSR-1/1P or PVV-3/3P
Indication Meaning
NO TAPE There is no tape loaded.
REC INHIBIT
The tape is in the recording inhibited
state.
The battery is almost exhausted.
LOW BATT a)
The battery is exhausted.
BATT. END
TAPE NEAR END The tape is near the end.
TAPE END The tape is at the end.
A device other than a remote control
CHECK REMOTE
unit (e.g. headphones) is connected to
(PVV-3/3P only)
the REMOTE connector.
SERVO The servo lock has been lost.
52
Chapter 4 Viewfinder Screen Indications and Menus
a), b), c)
PLAY TAPE NEAR END
RET1 TCG 12:34:56:00
ABCD1234
5600K
64ND SKIN W:A 36dB 100.4H
c)
04 08 01
12:34:56PM
:::::::: 30-25 F5.6
Z
Indication Meaning
There is condensation.
HUMID
RF
The video heads are clogged, or there
is some other fault in the recording
system.
SLACK
The tape is not wound properly.
OXIDE TAPE An oxide tape has been loaded. (The
(PVV-3/3P only) tape is automatically ejected.)
a) Even if a VTR is not connected, LOW BATT is displayed
when the voltage of the power supply to the camera head
fall to or below 11.0 V.
c), d)
qh Clock indication
qg Lens f-stop indication c)
qf Tape remaining indication a), b), c)
qd Audio recording level
indicators a), b), c)
c)
qs Shutter setting indication