Fitting A Vtr - Sony CCU-TX50 Operating Instructions Manual

Fitting a VTR

This section explains how to attach the DSR-1/1P to
the camera head. The method for attaching a PVV-3/
3P is similar.
1
Set the PRO 76-pin DIGITAL
connector on the DSR-1/1P.
(The camera connector on the
PVV-3/3P is PRO 50-pin.)
For details, see the operating
instructions for the DSR-1/1P.
2
Loosen the two screws and
slide the shoulder pad as far as
it will go toward the front.
3
Align the projection on the
bottom of the DSR-1/1P with
the slot on the camera head.
4
Slide the DSR-1/1P and the
camera head together in the
groove as far as possible.
Tighten the two screws in the
grip connector and the two
screws in the shoulder pad
section.
When replacing the camera head grip with a camcorder
grip, see "Using the Camcorder Grip" (page 26).
Camera head
VTR (DSR-1/1P)
Camera connector
(PRO 76-pin DIGITAL)
Screws
Slot
Projection
Groove
Chapter 2 Fitting and Connections
25