Controllers: Assignable Sliders; Controllers: Ec5 - Korg Pa3X 76-keys User Manual

Touch the "Push" button in the display to confirm the max-
4.
imum value. The following dialog box appears:
You are now asked to set the pedal to the minimum value.
5.
Release the footswitch, or press the pedal to the minimum
position (usually back pressed).
Touch the "Push" button in the display to confirm the min-
6.
imum value.
Check if the pedal or footswitch is working properly, assign
7.
it a function, then save by choosing the "Write Global-
Global Setup" command from the page menu.
Note: After loading a new Operating System, an older Global file,
a "SET" folder containing an older Global file, or a Backup file,
you might need to re-calibrate the pedal/footswitch.
Damper
Calibration
Use this button to calibrate the action of the Damper pedal, and
set its polarity. See above for details about the procedure.
Ribbon
Sensivity
Use this parameter to adjust the sensitivity of the ribbon control-
ler.

Controllers: Assignable Sliders

This page lets you program the first eight Assignable Sliders.
Two sets are available (Assignable A and Assignable B). Two
other modes (Volume and Drawbars) are hard-wired to the vol-
ume and drawbars control. You can assign the preferred set by
using the SLIDER MODE button on the control panel, cycling
between the four available modes. The status of the SLIDER
MODE button can be saved with a Performance or STS.
Assignable Sliders A/B
Functions assigned to the corresponding sliders on the control
panel, when the selected mode is ASSIGNABLE A or B.
See "List of Assignable Footswitch / Pedal functions" on
Gbl
page 239 for a list of the assignable functions.

Controllers: EC5

This page lets you program each of the five switches of the
Gbl
(optional) KORG EC5 multiswitch pedalboard.
See "List of EC5 functions" on page 242 for a list of the assign-
able functions.
EC5-A...E
Each of the switches of a KORG EC5 multiswitch pedalboard.
Global edit mode
Controllers: Assignable Sliders
209
Gbl
Gbl