Controllers: Pedal/Switch - Korg Pa3X 76-keys User Manual

Global edit mode
208

Controllers: Pedal/Switch

discharges. When turning the instrument on again, PCM Sam-
ples are loaded again from the internal storage memory.
Please note that all other data contained in RAM (Songs, MIDI
Grooves, Samples that have not yet been saved) are not pre-
served by the battery, so please remember to save any new or
modified data before turning the instrument off.
Use this page to check the level of charge of the battery preserv-
ing the PCM Sample RAM, and the remaining charge time. The
battery is charged when the instrument is turned on (or in
Standby mode), and discharges when turned off or entirely dis-
connected from a power outlet.
Charge
This bar shows the current level of the battery.
Duration
This indicator shows the remaining charge time. Please note this
is just a forecast average, and not the exact time.
Wipe
Use this button to completely discharge the PCM-memory
backup battery, after replacing the battery pack or installing the
PCM Sample memory expansion.
Error messages
(Only appears in case of malfunctioning.) When the STANDBY
red and green LEDs are flashing, there is a malfunctioning in the
backup battery. The following messages appear in this page.
Unplugged battery: The battery is disconnected. Please check if
it can be reinserted.
Battery is damaged, please replace it: The battery is damaged or
exhausted, and can no longer be recharged. Please replace it with
the same type and model.
Controllers: Pedal/Switch
This page lets you select a function to the Assignable Pedal/Foot-
switch, and select the polarity for the Damper and Assignable
Pedal/Footswitch.
The following (optional) Korg pedals are compatible with Pa3X:
Type Model
Continuous EXP-2, XVP-10
(Volume/Expression)
Switch PS-1
Damper DS1H (supporting half-pedalling)
Pedal/Footswitch
Function
Function assigned to a continuous (i.e., volume/expression)
pedal, or to a footswitch, connected to the ASSIGNABLE PDL/
SW connector. See page 242 for a list of the assignable functions.
The first functions are switch-type functions, while the remain-
ing (starting from Master Volume) are continuous-like func-
tions.
Calibration
Use this button to calibrate and choose the polarity of the pedal/
footswitch.
Connect the pedal or footswitch to the ASSIGN PEDAL/
1.
SW connector on the back of the instrument.
Go to this page, and touch the "Calibration" button in the
2.
display. The following dialog box appears:
You are asked to set the pedal to the maximum value. Press
3.
the footswitch, or press the pedal to the maximum position
(usually front pressed).
Gbl
Gbl